Alternators
Chrysler LeBaron
Rodeo Events

How do you replace the alternator on a 1993 Chrysler LeBaron?

333435

Top Answer
User Avatar
Wiki User
Answered
2005-12-02 14:32:41
2005-12-02 14:32:41

You will first need to loosen the serpentine belt in order to remove it from the drive pulley. After that, it is bolted to the engine in 2 locations, which should be rather obvious, then remove electrical connections.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


A 1993 Chrysler LeBaron is fuel injected and does not have a carburetor.A 1993 Chrysler LeBaron is fuel injected and does not have a carburetor.


ffs.. it ain't rocket surgery.. follow the instructions on the box



I have a 1993 Lebaron with 3.0 Liter and Automatic. I get between 23-26 mpg.









i had the same prob. with mine i have a 92 lebaron 3.0 and it was the fuel pump going bad...


The sensor in the distributor is the crankshaft position sensor.


It is under the plastic covers on the passenger side of the engine.



Take it to a professional. This is not a DIY job.



check your transmission control relay.. it might be stuck..


Turn the radio on and press sel twice for hours and once for mins


It is located under the housing where the upper radiator hose attaches to the engine.


There is no fan belt it is an electric fan. Are you referring to the serpentine belt?


If you mean the radiator drain plug.. its at the bottom of the radiator on the left hand side...


It is behind the engine mount on the front of the block.


I have the same issue. I would look at the over drive sensor/module as the culprit


Remove the belt from your 1993 Chevy G 20 alternator. Remove the alternator wiring harness. Remove the retaining bolts from the alternator. Reverse the process to install the new alternator.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.