answersLogoWhite
Alternators
Buick
Nissan Frontier
Rodeo Events

How do you replace the alternator on a 1995 Buick V6?

757677

Top Answer
User Avatar
Wiki User
2015-07-15 19:36:47
2015-07-15 19:36:47

Remove the negative battery cable then use a wrench to take the tension off of the belt and make sure there is a schematic on the fan shroud for the routing of the belt. If not draw one before removing it. Then take the wires off of the rear of the alt then the bolts and work it out.

1

Related Questions

User Avatar

how to replace the alternator on 2006 mustang v6

User Avatar

How do you replace the water pump and where is it located on a 1996 Buick Skylark V6

User Avatar

Where is the theft deterrent module on 1995 Buick Regal

User Avatar

well you dont repair the gasket itself you just replace them.

User Avatar

visit www.newtiburon.com for step by step

User Avatar

The Buick, Chevy or Ford 3.8 V6, it makes a difference.

User Avatar

AnswerHow to replace starter for 1996 Buick Regal #.8 Liter 6cyl

User Avatar

I just looked at www.oreillyauto.com and found that for the 4 cylinder engine the alternator is $139.99 and for the V6 it is $169.99.

User Avatar

not charging the battery properly... check the alternator.

User Avatar

www.autorepairdb.com/audi/clutch1.html has a guide for a 1998 V6. I think the procedure is pretty similar to 1995.

User Avatar

yes, once the alternator is removed from the bracket, the axle and exhaust interferes with the removal of the alternator from the vehicle.

User Avatar

how do you remove alternator on v6 holden vectra

User Avatar

how to install dist. on a buick 225 v6

User Avatar

Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.

User Avatar

the spark plugs are located on the front of the engine under the hood

User Avatar

Use a large wrench to take tension off of your serpentine belt and remove the belt from the alternator, (just the alternator). Disconnect the wires. Remove the bolts then the alternator. Put new alternator in place using old bolts. Replace wires (may only be one wire, depending on the alternator). Get your large wrench back out, put the belt back on the alternator, and your good to go.

User Avatar

3.8L 225 hp SC L67 Buick V6 "supercharged version of the 3800 V6 rated at 225 hp (168 kW) and 275 lb·ft (373 N·m)." http://en.wikipedia.org/wiki/Buick_V6_engine#Series_I

User Avatar

The torque strut mount must come out along with the mount to remove the alternator


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.