Mitsubishi Eclipse

How do you replace the alternator on a 1996 Mitsubishi Eclipse gs?


Top Answer
User Avatar
Wiki User
2006-12-11 02:19:14
2006-12-11 02:19:14

There is a pully that will ratchet up and down to loosen or tighten the belt. Take the belt off, unplug the wire from the alternator, and there should only be 2 or 3 bolts holding the alternator on.


Related Questions

Wilson the alternator belt. With the tensioner pulley. Remove the wiring harness from the alternator. Remove the four alternator retaining bolts.

Because Mitsubishi Eclipse 1996 doesn't have automatic headlights.

If you go to you can view repair guides online free.

how to replace alternator on Toyota 4 runner 1996

go to and go to vehicle repair guides

The second generation Mitsubishi Eclipse was put into production from 1995 to 1999. The convertible model called the Mitsubishi Eclipse Spyder was put into production in 1996.

The 1996 Mitsubishi Eclipse ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

go to and they have online vehicle guides.

drain the coolent remove timing belt.....loosen bolts....4g63, take off accessory belts and remove

go to autozone or other parts store and buy a haynes auto manual for your specific model it should tell you how to remove it.

covers the struts and composes a large part of your suspension system.

I need a step-by-step how to change, remove and replace an alternator in an 1996 Nissan maxima

The regulator is part of the engine computer on a 1996 Jeep. It is not in the alternator.

Insufficient charging from your generator (aka alternator).

the difference between gerund and present participle

If you go to you can view repair guides online free.

no you cannot due to the cam set up in the car

I had the same problem with my Eclipse it was the spyder turbo i had put cheap gas in it. went to 93 octane had no problems.

The approximate cost of replacing an alternator on a 1996 Toyota Avalon depends on whether you do it yourself or have a shop replace it. The alternator costs around $125 and it would take about two hours of labor for a total of approximately $300 if a shop did it.

If you look near the fire wall (the metal under the hood latch) to the left youll see the belt. Well if you have a flash light available youll see the belt connected to a circle device with holes, inside the hole youll see a copper colored coil. that's your alternator

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.