Ford Ranger
Ford Ranger XL
Ford Ranger XLT

How do you replace the antenna on a 2000 Ford Ranger?

888990

Top Answer
User Avatar
Wiki User
2011-09-12 20:53:57
2011-09-12 20:53:57

first pull out the radio and undo the antenna plug from the back of it. Tie a 6 foot peice of bailer twine or similar string to the end above the plug, and tape it on. Next undo the screws in the plate holding the antenna to the fender of the truck( if that is the type you have). Pull the antenna wire out until you get about 6 inches of the string. Tie the string to the plug on the new antenna and tape it on. Go back into the cab and pull the string until you can get the plug. Pull the plug until you can plug it into the radio. Reinstall the radio. Go back to the fender and feed the rest of the antenna wire into the hole and put the screws back through the plate to hold the new antenna in place. If it doesn't have screws and plate, then the antenna is held on by a nut under the fender, and you need to undo the wheel well liner to get at it. good luck.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do i replace front wheel bearinbs on 2000 ford ranger 4wd

User Avatar

can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?

User Avatar

How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it

User Avatar

How do you replace a 2003 Ford Ranger radio

User Avatar

The antenna connection, for your 2000 Ford Taurus, is on the back of the radio. The antenna cable goes from the radio to the connection in the windshield.

User Avatar

The antenna should be screwed on and is mine came off with a ten millimeter wrench. The new one should screw right on. The JD Kid

User Avatar

where are the fuseible links located on a 2000 ford ranger

User Avatar

how to replace water pump on 2001 ford ranger

User Avatar

bolt pattern for 2000 ford ranger & ft pounds

User Avatar

how to replace u-joints on 1995 ford ranger 2wd

User Avatar

The antenna screws into the mount on the roof

User Avatar

what type of radiator fluid does a 2000 ford ranger take?

User Avatar

No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )

User Avatar

5W-30 , according to the 2000 Ford Ranger Owner Guide

User Avatar

Bank 1 is the passenger side of a V6 engine in a 2000 Ford Ranger

User Avatar

How do you install a rear sliding window on a 2000 Ford Ranger?

User Avatar

how do i replace a throttle cable on a 1988 ford ranger pickup

User Avatar

How do your remove the dashboard on a 2000 Ford Ranger?

User Avatar

How much weight can i pull behind my ford ranger 2000 xlt

User Avatar

Will a 1997 Aerostar transmission fit in a 2000 ford ranger?

User Avatar

If you're talking about the 4.0 L V6 ( NO ) The 2000 Ford Ranger 4.0 L was the OHV and the 2004 Ford Ranger uses the 4.0 L - SOHC - engine

User Avatar

Begin by removing the cable from the bottom of your 1997 Ford Taurus antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

User Avatar

The pcm computer is mounted on the firewall on a 2000 Ford Ranger. It is on the passenger side under the hood.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.