answersLogoWhite
Toyota Paseo
Toyota Tacoma

How do you replace the antenna on the 1992 Toyota Paseo?

888990

Top Answer
User Avatar
Wiki User
2008-07-11 19:27:47
2008-07-11 19:27:47

1. Remove radio 2. Unplug antenna cord (usually on the left of the radio as you are facing the radio) from the back of the radio. 3. Thread antenna cord by gradually pulling it through to where a hole is located down and in front of the driver's side car door(this is where the antenna cord comes down from windshield/window column). 4. Tie about four feet of a strong line or string to the end of the antenna cord plug (this will help when threading in the new antenna cord). 5. Unscrew the two screws holding the antenna assembly near the roof on the windshield/window column. 6. Carefully pull the antenna assembly up from the windshield/window column at the same angle as the column. Do this until the end of the antenna cord, with the string attached to the plug, is visible. 7. Untie the string or cord from the old plug and tie it on to the plug of the new antenna cord. 8. Carefully pull the attached string or cord from the hole located down and in front of the driver's side car door. At the same time make sure the cord is being fed through the hole where the antenna assembly fits. Keep pulling on the new cord until its plug appears at the hole located down and in front of the driver's side car door. Pull the new cord out through the hole eliminating all of the slack in the new cord. 9. Repeat steps 1 through 5, but in reverse order. Added: Excellent advice was given above. I was able to replace the antenna on my '92 Paseo. One word of advice: You may have trouble pulling up the antenna assembly up from the windshield/window column. This is because there are two clips located underneath the steering wheel assembly that are holding the antenna cable in place. I found this by accident when I was following the antenna cable starting from the end ( that plugs into radio) along underneath the steering column.

1

Related Questions

User Avatar

where is the flasher located on a 1992 toyota paseo

User Avatar

log onto Google, click on images, type in 1992 Toyota paseo.

User Avatar

How do you replace a 1992 Celica GT antenna

User Avatar

I have a 1992 Toyota Paseo and I use 5W-30 engine oil in it. Always have and that's what the owners manual recommends.

User Avatar

Where are the timing marks on a 1992 Toyota Paseo 16 efi 1.5 liter engine?

User Avatar

Manual transmission = 2.5 u.s. qts. Auto transmission = 3.3 u.s. qts. source = 1992 Toyota Paseo repair manual

User Avatar

To remove the window crank on the 1992 Toyota Paseo, first pry off the interior door panel. Then, access the screw that holds the crank in place. Remove the screw and the handle will come loose.

User Avatar

Check out toyotanation.com They have a forum dedicated to paseo,tercels,startlets They also have a common engine swap guide there.

User Avatar

the best deal you can get is if you buy the radiator on eBay it will cost you between $50 -$60 and then take it to a technician to change it , also it is very easy to replace it , you can do it yourself

User Avatar

Hi , i have 205/45/16 on my 1992 Paseo and there are no issues. Dont think they will be any different on the 96 Paseo

User Avatar

Most antenna in cars can just be unscrewed at the base. You may have to disconnect a wire at the base though. Check your owner's manual or a car repair manual for more details.

User Avatar

Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine

User Avatar

How do i replace speed sensor on 1992 toyota previa and where is the sensor located

User Avatar

This car doesn't have a serpentine belt. It has 2 drive belts.

User Avatar

Under the vehicle attached to the exhaust pipe between the engine and the muffler.

User Avatar

It would be a good idea to change it if you replace your water pump. Save you from having to pull that motor back up at a later date.

User Avatar

Begin by removing the wiring harness from your 1992 Nissan antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

User Avatar

remove wheel and remove the plastic liner inside the fender. remove the radio and disconnect the antenna wire. Tape another, 10' long wire to the end of the antenna wire. Unscrew the nut around the antenna from on top. pull the antenna and antenna wire out through the fender. Tape the 10' long wire to the new antenna wire and pull it back through the dash to the radio.

User Avatar

MOST CAR SHOPS PEPBOYS OR EVEN WALMART HAS THEM 9003-HB FIT MINE

User Avatar

how do you install a water pump on a 1992 toyota camry

User Avatar

Mine does. It will ride 2 small people comfortably. Can't remember if there is a middle seat belt.

User Avatar

Remove left rear wheel plastic housing cover under the body you can then access the antenna motor.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.