Remove left front wheel. At the front of the wheel well there is an access door for the battery. Remove it by either turning the fasteners 1/4 turn or, if there are push fasteners, pop up the centers of the fasteners and then you can pull out the whole fastener. Disconnect the cables, then disconnect the battery hold-down and remove the battery. You may have to remove the battery heater blanket if there is one.
The owners manual claims that it is possible to remove the battery without removing the wheel, just turn the front wheels all the way to the right. Because of the cumbersome weight of the battery, you are probably better off givingyourself the extra working space by removing the wheel. Suppport the car properly with a jack stand. Don't rely on the car jack to hold up the car while you are Wrestling around with the battery.
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
Scan tool or unhook the battery.
A 2002 Chrysler Sebring was not built with a cabin filter.
No, in 2002 the Chrysler sedan was a Sebring.
A 2002 Chrysler Sebring convertible does not have a maf sensor.
Depends on where you get it done but was $365 for me. Yuck!
A 2002 Chrysler Sebring sedan does not have a MAF sensor.
It is not a direct swap. They use different transmissions, computers, wiring, etc.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.
I have a 2002 Sebring Limited Convertible and my battery is located and "accessable" on the driverside front wheel well. To change the battery you need to turn the wheel all the way to the right and remove a cover to expose the battery. Good Luck! it's no easy task!
The 2002 Chrysler Sebring OBD 2 port is underneath instrument panel, near steering column
you must drop the fuel tank, its held on by 2 straps(bolts)
NO, Dodge doesn't have a reset button.
It does not have one.
You can unhook the battery or use a scan tool.You can unhook the battery or use a scan tool.
You hook the charger to the red and black jump start posts under the hood on the driver side.