Car Batteries
Chrysler Sebring

How do you replace the battery in a 6 cylinder 2000 Chrysler Sebring convertible?

181920

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 20:54:04
2011-09-12 20:54:04

I believe the front dirver side tire must be removed in order to gain access to the battery.

The 1999 owner's manual says turn the steering wheel as far left as possible. Removing the wheel/tire is not required. Of course, when a battery replacement is needed, the engine can't be started so the power steering won't operate. Maybe removing the wheel is easier. Typical Chrysler engineering. Yes, I have one.

Taking the wheel makes it much easier. Be sure to block the opposite side rear wheel since you will be working under the jacked up car inside the wheel well. You will need a Phillips head screw driver and 3 different wrenches to get it out, 3/4" for the wheel nuts, 13mm for the bsttery hold down clamp/strap and 8mm for the battery cables. As the proud owner of a '96 JX I can strongly recommend removing the tire to access the battery. The battery is behind the plastic splash panel. Remove the numerous Philips head screws and wrestle out the panel. You'll then be able see the battery. Mercifully, by the way, jump starting can be done using the lugs under the hood on the left wheel well.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I have a 99 and the battery is in the driver side fender.

battery is stored in a compartment behind the left front fender

It is inside the driver side fender, in front of the tire.

On a coupe, it is under the hood. On a convertible, it is inside the driver side fender.

it is located in the front drivers side wheel well. you need to remove a few screws to get to it.

You hook a battery charger to the red and black jump start posts under the hood.

Coupe, under the hood. Sedan and convertible, inside the driver side fender.

Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

There is no reset on a 1996 Chrysler Sebring.There is no reset on a 1996 Chrysler Sebring.

The battery on a two door coupe is under the hood. The battery on the convertible is inside the driver side fender, in front of the wheel.

Coupe, under the hood. Convertible, inside the fender, in front of the driver side tire.

it takes a group 75. a good battery would be an ac delco 75-60.

where do I find the battery on a 1999 Chrysler sebring, can't find it in the engine compartment?

You can use a scan tool or unhook the battery after repairing the cause of the fault.

It is located in front of the left front wheel, inside the fender. You have to remove the wheel and fender liner to access.

Under the hood on the driver side are positive and negative jump start posts. The cables attach there.

I have a 2002 Sebring Limited Convertible and my battery is located and "accessable" on the driverside front wheel well. To change the battery you need to turn the wheel all the way to the right and remove a cover to expose the battery. Good Luck! it's no easy task!

The driver side front tire, and inner fender liner need removed.

The battery, on a 2010 Chrysler Limited Sebring, can be changed by first removing the battery cover. Remove the battery cables and the retaining bolt. The battery will left out. Reverse the process to install the new battery.

it is very easy to change the battery on a 2001 Chrysler Sebring. You just need to take the battery terminals off the old battery and then replace with the new battery. Make sure to replace the terminals on the correct battery post.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.