How do you replace the blower motor in a Mitsubishi?
Which model of Mitsu? Some are behind the glove box, and you must take the box out and a nut or to from the firewall, and the blower should be clear from then.
1988 mighty max 2.0L
If the blower stopped working my 2001 Kia Spectra could this be the motor blower resistor or should I replace the blower motor?
How can you figure out which to replace the blower motor or blower motor resistor on a 1994 Nissan altima?
under the glove box there is a panel that holds the blower motor...remove the screws...4 i believe....remove the black plastic cover....there are three screws that holds the blower motor in...remove these and then remove the blower motor...unplug the power source and feed wires out of the hole.....reverse to replace the motor
I think I found the blower relay on my 97 escort behind the drivers side kickpanel I have power at the relay or fuse but I have no power at the blower switch what could be defective?
The blower motor is under the hood near the passenger side strut tower. To replace it: 1. Unplug the electrical connections. 2. Remove the screws that hold the motor in place. 3. You may need to move the alternator out of the way to get clearance to pull the blower motor out of the heater vent. Reverse the process to install a new blower motor.
* Disconnect the negative battery cable * Remove the glove compartment and lower dash trim to gain access to the heater case and blower motor * Detach the blower motor cover and disconnect the electrical connector from the blower motor * Remove the blower motor mounting screws and pull the blower motor carefully out of the housing * If you are replacing the motor detach the fan and transfer it to the new motor