TAke the light assy off.
...the light assebly can be accessed from inside the bed, if you have a bed liner it must be removed or at least pulled back. there should be two or three large screws on the inside of the bed that need to be removed. the assembley will now be free to move the slack of the wires. a simple twist and then pull will get the light out. Nissan had a recal on tail light assembleys a while back because the lights would loose connection inside the housing, some electrical grease would fix that. or you can take it by your local Nissan dealer and complain until they ablige. take some papoer work with you, recals can be found at "alldata.com"
on the brake pedal
check and see when your brake pedal is not pushed down if it is pushing the brake swith pin back in if so you need to replace the brake light swithch located behind the pedal
3rd brake light or rear brake lights?
disconnect it from your brake pedal lever.
The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.
There are two bolts inside of bed unbolt to remove taillight. Remove bulb, push down slightly and turn. Replace with new and reassemble.
Those tail lights could be the brake lights you are seeing and that would be a faulty brake light switch or the brake light switch is out of adjustment.
how to replace lower ball joints on 1995 4 wheel drive Nissan truck
Cut it off and replace it with a new one.
Drop the tailgate, pull back the bed cover on the corner behind the break light you want to replace. There are bolts back there that hold the light in place. Undo those bolts and the light will come out easy. Replace and tighten bolts back and you are done. Very easy to do with some mechanical skills.
I have an 87 Aero Coupe and my 3rd brake light bulb is in my truck. I think yours would be the same too.
you will have to replace.
If your talking about the brake bleeder, it is on the caliper/brake cylinder at the wheel.
brake calibers might need replacing,the pistons might be getting stuck,its easy to replace.
The way to replace a door handle on a Nissan pickup truck can vary depending on the year of the truck. There are several tutorials available online.
Where is the brake light switch for 2003 hd Chevy truck As far as I know, all brake switches are on the top of the brake pedal arm.
Some companies make caps that are made to fit around the third brakelight.
It's just above the brake pedal, connected to the brake pedal arm. The switch comes out with two screws and the new one plugs in. But before you replace the switch, check the adjustment.
The brake light switch relay for your 1997 Chevy truck is located beneath the drivers side dashboard. The brake light relay switch will be above the brake pedal.
I had the same problem. There is a small nipple-typed fitting near the brake pedal under the dashboard. This is the spacer and mechanical silencer for the brake switch. Mine was missing, presumably worn out by age. Only Nissan dealers have this part, for around $5.00. It takes about 30 seconds to replace.Locate the brake switch.Check the area of contact when the switch is released. There should be a hole there.Press the part into the hole.
where is dash light and tail light relay on 1984 nissan pickup truck
I believe you have to unscrew a couple bolts on the inside of the truck bed to get the taillight assembly off the truck then you can unscrew the light sockets and replace the burnt out bulb
check you brake fluid level.