If you are talking about the back-light in the stereo, you can replace it, but this is not very effective as that you have to remove the unit and take it apart, your best bet is to buy an after market stereo and install it yourself (you still have to remove the old unit plus install the new one but w/o the hassle of taking anything electronic in nature apart). You can get nice after markets for under 100 and the wire harness, and dash kits usual run around $20 combined. Installation usually takes an hour plus time for wiring and kit setup. Time and money wise to install an after market vs. repairing the stock stereo it is easier to just replace the unit. To have the original repaired costs an average of $150-$350 depending on the repair and a replacement itself usually runs around $200 from a junkyard (more from the dealer itself). Hope this helped
changing the bulb
On a 1998 Grand Am gently press the front and back of the dome light housing, that should release the housing and the clear plastic.
How do you replace a turn signal bulb in a 1998 cavalier
wjjeeps.com . they show how to replace every light and with what bulb
To change a tail light bulb on a 1998 grand prix you have to first take out the carpet from the trunk. Next, you will be able to get to the bulb just remove the case holding covering the bulb then twist, remove and switch the bulb.
Get a flat head screwdriver and pop it off...then replace the bulb
the headlight assembly needs to come out in order to replace the bulb.
Remove the dome light lens, pull the old bulb out, and replace with new bulb; replace the lens.
You replace the bulb the same as a 1998, which is answered further down the page.
You should be able to go under the hood and remove a cover. This should reveal the back of the light enclosure. Just remove the bulb and replace it with a brand new one.
How do I change a headlight bulb on a 1998 jeep grand cherokee?
Remove the two 10 millimeter screws and pull the housing down and replace the bulb
how to replace standing lamp in 1998 e320
To replace a headlight in a 2006 Suzuki Grand Vitara first open the hood. Prop it safety up and locate the headlight housing. Remove the bulb from the housing and replace the unit.
Yes , according to the 1998 Mercury Mountaineer Owner Guide : ( the headlight bulb is # 9007 )
On the 1998 Audi A6, the turn signal bulb can be replaced by opening the hood. Reach into the turn signal from the fender wall and push in and turn the old bulb to remove it. Push in and turn to replace with a new bulb.
Just the bulb. Tried following the directions in the owner's manual, no joy. The bulb or the whole unit?
Replace the bulb that is burnt out.
Push in and turn.
cant be done
iT PROBABLY IS THE BULB SO SEE WHICH ONE EITHER FROMTOR REAR IS NOT BURNING AND REPLACE IT.
Assuming this is for one of the 2 rear fog lamps, then remove the three bolts from the rear lamp housing. The fog lamp is the bottom bulb in the set. Give the bulb holder a quarter turn anti-clockwise and remove the bulb and holder from the lamp housing. The bulb is held in place by a plastic clip either side. Spread the clip sideways slightly and the bulb will pull out. Put new bulb in and replace.
The license plate light bulb on a 2002 Pontiac Grand Prix is replaced by removing the retaining bolts and pulling the bulb out of its socket. A new bulb is then put into the socket and reassembled.
Pull out on the plastic plug attached to the bulb the whole bulb will come out, pull apart the plastic adapter to the wire and the wire connector, then attach new and replace.