There are three little screws under the headlight switch/knob thing, and three screws under the wiper control knob/switch thingy... take those out. Place both hands on top of your dash and PULL towards you, and it will pop off... do not be afraid to pull... Ok, then you unplug the wires to the headlight switch, and then you do the same to the two plugs connected to the wipers. Set the dash on the passenger seat for now... OK! Step one! How easy! Now you need to take out the Black, (not gold) screws, and pull out the instrument panel, also don't be afraid to give that a nice tug too,... Now, with the panel in your hands, flip it over the its backside and marvel how cool it looks... then find the 4(I think)light bulbs!!! There is one indented in the center, one to the right, one to the left... they are about 1/2 in. wide and round... now... I realized that that was not my problem... the bulbs were not burnt out... check the fuses (drivers side, with door open, inside dash, with a cover that says 'fuses' on it :)... I did that ages ago... as it said #15 or something is Instrument Panel (3 watts) it turned out to be the S.I.R fuse.
Hard to do , didn't Corsicas only start in 88??
Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?
A Haynes or chiltons manual has the how to. Or do a search for a forum for Chevy corsica specific
It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.
cost to replace heater core 1994 corsica
You need to remove the dash in order to get back there to replace any blown bulbs.
Correction: It is a 1995 Chevy Corsica. Not a 1996.
The side view mirror on a 1995 Chevy Corsica is mounted by screws. Remove the screws and panel for the mirror on the inside of the vehicle. Pull and replace the unit.
yes you need to replace head bolts
where do most federal government dollars come from
the wire is bare how do you replace the wire with out removing the dashboard on a 1993 Chevrolet corsica?
i belive you mean Chevy Corsica right ?
Bring to a shop that has an ABS scanner to determine the problem
The Corsica wasn't made in 1898. I think you have to slap it with the reins to make it go on that model.
4 CYL V-6 ? NEED MORE IMFO
I find that Autozone is very helpful in answering automotive questions.
The gas tank on a 1990 Chevy Corsica is 15.6 gallons. A 1990 Chevy Corsica takes unleaded gas not premium.
There are seven steps on how to replace the EGR valve in a 91 Chevy Corsica. Some of the step-by-step instructions are disconnect the car battery, unhook the air supply hose, and remove the EGR mounting mounting bolts with a socket wrench.
Begin by removing the alternator belt on your 1989 Chevy Corsica. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
A 1989 Chevy Corsica 2.0 sedan weights about 2595 pounds. The 1989 Chevy Corsica 2.0 automatic sedan weight 2623 pounds.
Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
You have a blown instrument lights fuse or it is just turned off. There is a rheostat that controls the brightness of the lights. Find it and adjust the brightness.
If you are talking about all the interior lights being on...then on the knob that turns the headlights on and off the part that sticks out is also adjustable, where you can control how dim the instrument cluster is, anyway its probably set to on so just click it off, i believe turn it down.
where is the over drive solenoid located on a 1989 Chevy Corsica