Begin by removing the cylinder head from your Chevrolet S 10 four-cylinder engine. Remove the head gasket and clean the surface. Put the new head gasket on and return the cylinder head to its original position.
Outside the engine
Crankshaft Position Sensor1995 Nissan/Datsun Truck Pickup 2WD 2.4L SFI 4cylThe Crankshaft Position Sensor is located:Under hood, driver side, upper engine area, mounted in rear driver side of engine block
There is NO adjustment, You must replace the clutch set to bring the pedal back to the right position. You also need to make sure the clutch slave cylinder/ master cylinder is good before replacing clutch assy.
8 cylinder 360
yes ther is.
From a crankshaft speed/position sensor.
96 and 97 go together .no 87.
It is part of the distributor. You have to replace the distributor
On my 95 pickup with 4 cylinder engine, the thermostat is located where the lower radiator hose enters the engine block. Hope this helps.
its inside of your gas tank.
call a locksmith to replace the lock cylinder and key.
Position 1. Bridge Pickup, Position 2. Bridge and Middle Pickup, Position 3. Middle Pickup, Position 4. Middle and Neck Pickup, Position 5. Neck Pickup
For the Ford 4.9 liter / 300 cubic inch , inline six cylinder engine : The firing order is ( 1 - 5 - 3 - 6 - 2 - 4 ) The distributor rotor turns CLOCKWISE The marked # 1 position on the distributor cap faces AWAY from the engine The engine cylinders are numbered 1 to 6 , from front to rear
follow your top radiator belt,its inside the thermostat cover.2 bolts hold it on.
Replace the engine coolant sensor.
800.00 to1100.00 used
$1,870.00 to $3,592.00 with a 4-cylinder engine.
where is the cranksensor on 1994 chevy pickup with a 6.5 engine
depending on if it has a v-6 or a 4 cylinder. Most were manufactured with a 22R Engine (4 cylinder)
The engine computer is the voltage regulator, and yes you can replace it.
yes you can replace it. i have replaced many engines and i know you can replace that.
Driver's side closest to the front