Make sure you disconnect the slave cylinder and take out of the transmission before you remove the transmission. Remove transmission, remove pressure plate & throw out bearing, and your clutch will fall off. Then just do in reverse - make sure you line the splines on the clutch. You can get an alignment tool from the parts house to make the transmission go in easier.
How much oil do I put in a 1996 Isuzu rodeo
It has a 3.2 v6 4x4
how do you find out how to check the transmition in a isuzu rodeo
every 30 thousand miles and replace it every 60K
No it is not, in 1996 Isuzu bumped the horsepower of their 3.2L V6 up to around 195 hp and 193 ft·lbf of torque for the 1996 and 1997 Rodeos continuing into 2004 in which Isuzu operated here in the states under GM dropped the Rodeo line
top of gas tank
disconnect the battery
it¨s a timing belt..
drop your transmission if it is a manual you have to remove the clutch and pressure plate or automatic the torque converter has to be removed and it should be right there but its hard to get out some times
The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.
simply logon to /www.myisuzuparts.com/index.php
Its in the alternator
The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.
how difficult is it to replace the MS on a 1996 Honda accord
in the fuse box ,on the drivers side of the dash.it is a 30 amp circuit breaker.
Same as any other car its located under the car attached to the engine
I own a 1997 Isuzu Rodeo and had the same problem. I went to a local Isuzu new-car dealer and was quoted a price in excess of $100 to replace the burned-out dashboard lights. I was told that the cost is high because the top of the dashboard has to be removed in order to obtain access to the lights. I did not have the lights replaced. carlpers
remove the 2 screws from the red plastic and gently pry the red cover off.
it is possible to make a snorkel for a 1996 Isuzu rodeo. most snorkels are home made by just extending the air intake through the fender of the car using PVC piping and what is called a "hat", which is the tip containing a filter to block debree and dirt. making a snorkel requirs alot of measuring.
If it is the same as a 1996 it will be top row second from the front in the fuse box by drivers door.
A 1995.5 model has the updated interior similar to a 1996 model, but has the same drive-train as a 1995.