Want this question answered?
The clutch slave cylinder on a 91 Mazda 626 DX is located on the clutch bell housing. To replace the unit, first remove the hydraulic line and turn the line cap counterclockwise. Remove the two bolts holding the slave cylinder in place. Reverse directions to install new unit.
How do you replace a slave cylinder on a 1995 dodge neon clutch
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.
there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.
The transmission has to be removed to gain access to the clutch slave cylinder.
Remove the transmission to excess the inturnal slave cylinder
You will need to remove the transmission to replace the clutch slave.
The slave cylinder is usually replaced during a clutch replacement. The slave unit is fairly inexpensive but the labor can be costly since most vehicles require the transmission to be removed to replace the slave. Since the transmission has to be removed to replace the clutch anyway, there is no extra labor involved to replace the slave.