answersLogoWhite

0


Best Answer

you have to remove the tranny and clutch! 4-6 hours depending on who and where you get it done and the tools they have most people charge about $70/$80/hr

User Avatar

Wiki User

โˆ™ 2015-07-15 21:20:18
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you replace the clutch slave cylinder on a 1997 Pontiac Sunfire?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much labor to replace a clutch on a 1996 Pontiac sunfire?

The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.


How do you tell if the clutch has in a Pontiac Sunfire?

We need more info here. How do you tell if the clutch has "WHAT" in a Pontiac Sunfire?


How do you replace the ac clutch on a 2000 Pontiac sunfire 2-2L?

Buy a Manual. ;)


How do I replace a clutch in 2000 Pontiac Montana?

It's an automatic, there is no clutch.


How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?

How do you replace the clutch slave cylinder on a 1989 jeep wrangler


How do you replace the slave cylinder on a 1995 dodge neon clutch?

How do you replace a slave cylinder on a 1995 dodge neon clutch


Should you replace your clutch master cylinder when replacing clutch?

At least the slave cylinder. The clutch master cylinder can be replaced at any time.


What could cause the clutch of a 2002 Pontiac Sunfire Clutch with 32K miles to go out and go all the way to the floor and not let you shift?

Either the clutch fluid level could have gotten low allowing air into the lines or you may need to replace your clutch master cylinder. Try adding DOT3 brake fluid and then pumping the clutch pedal. If you start to notice some resistance then you need to bleed the clutch hydraulic lines.


Disconnect Neutral safety switch Pontiac sunfire?

The neutral safety switch is found under the clutch pedal on a Pontiac Sunfire. Crawl under the cars steering column to see and reach the unit.


How do you adjust the clutch on an 89 Chevy 2500?

You can't, there is no adjustment. Time to replace clutch, slave cylinder or clutch master cylinder. 1 of the 3.


What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?

There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.


Clutch slave cylider location on a 1988 Pontiac Grand Am?

In a 1988 Pontiac Grand Am you will find the clutch slave cylinder located on the flywheel. You will need to remove the hush panel from the driver's side foot well to gain access to the clutch slave cylinder.

People also asked