Hyundai Accent

How do you replace the compressor in the AC unit of a 1997 Hyundai Accent?

464748

Top Answer
User Avatar
Wiki User
2015-07-15 21:14:45
2015-07-15 21:14:45

Sorry, but this is not a job for a DIY-er. Leave this to a technician who is certified in AC repair.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you replace antenna on a 1997 hyundai accent

User Avatar

a certified mechanic can do this for $350

User Avatar

Well in my 1997 accent it is located on the firewall in the engine if your engine is carburetor then it will be a plastic container

User Avatar

The horn on a 1997 Hyundai accent is located behind the front bumper. It is placed on the passenger side of the vehicle behind the right headlight.

User Avatar

The 1997 Hyundai Accent OBD 2 port is on lower edge of dash next to kick panel

User Avatar

The IAT sensor on a 1997 Hyundai Accent is found in the piping for the intake system. The sensor will be plugged and mounted near the air box for the air filter.

User Avatar

The water pump on a 1997 Hyundai Accent is replaced by first removing the timing belt and draining the coolant. The alternator needs to be properly marked and removed. Then unbolt the water pump. Clean off the old gasket and install a new gasket with the water pump.

User Avatar

how to replace AC compressor on a 97 Buick park Ave

User Avatar

The 1997 Hyundai Accent was equipped with the 1.5L 4-cylinder engine. The all season weight for this application is SAE 10W30 of API SL or better. It service fill with filter is 3.5-quarts.

User Avatar

above your rear foglight switchgear panel.. I am working on a 1997 Hyundai Accent at the moment. The connector for the OBDII is located on the left side of the dash. It is tough to see because it is facing down... recessed inside the cutout for the foglamps... at the top.

User Avatar

Remove the air conditioning hoses from your 1997 Chevy Malibu air conditioning compressor. Remove the compressor belt. Remove the compressor retaining bolts. Reverse the process to install your new air conditioning compressor.

User Avatar

This page will tell you how to do this......good luck. http://www.maintainyourcar.co.uk/1999_hyundai_accent_window_winde.htm

User Avatar

reverse lights on a Hyundai get there supply from a switch screwwed into the top of the transmission just left of the air filter box if your looking down at it

User Avatar

your slave cylinder is leaking,need to replace.

User Avatar

if it's anything like the location on a 1999 Accent, then it's at the front of the engine block, under the passenger side headlight. it is can be viewed from the under the car.

User Avatar

on the driver side. inside the corner front bumper on the driver side. easier to get to if you take out the turning light.

User Avatar

Its right in the back by the bumper in my 1998. You will see 2 hoses come of the filler hose that go right to it.

User Avatar

Check the clutch and see if it needs replaced; more then likely the compressor came apart on the inside and you'll have to replace it, flush the lines, and replace the orfice.

User Avatar

Hyundai dealers should be able to give the key code if you provide the Vehicle Identification Number and proof of ownership.

User Avatar

the relay is located on the left side of the steering wheel behind the diagnostic connector it is the middle on on the top row

User Avatar

The horn on a 1997 Hyundai is found mounted on the bumper of the vehicle. Remove the bolts that hold the horn down. Unplug the wiring and replace the horn.

User Avatar

If you do not have the recovery equipment and vacuum pump to draw the system down after installing the new compressor. You might want to leave the job to a shop that has the equipment. If you do it improperly it will void the compressor warranty and you will be buying a second compressor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.