I have a Saturn SC2, it shouldn't be that much different. You're gonn need to jack your car up because you can only get to it from the bottom. It's goona be a feeling game, but the crankshaft sensor is right behind the starter. You can see from the top to get a good idea where it is and another way is to follow the positive battery wire to the stater. To change the sensor you're gonna need 10mm rachet, the bolt will be first just fit around, remember it's a feeling game, just loosen the bolt and pull up, the sensor going to ba attached to a green connector with a yellow wire and a purple wire, unhook and replace with new sensor. When I changed mine today, I noticed my sensor was cracked. Any questions feel free to reply.
how to replace the crankshaft position sensor located in a 2003 kia rio
The 1998 Saturn SL2 will show a code 340 and 341 for a camshaft position sensor because this part is also considered the crankshaft position sensor on the Saturn. The location of the crankshaft position sensor is behind the alternator on a 1998 Saturn SL2. Both crankshaft and camshaft are the same thing This vehicle is not equipped with a camshaft position sensor. Saturn is the only manufacture that uses a auto pulse generated inside the ignition control module in conjunction with the pulse received from the crankshaft position sensor to determine ignition and injection timing. If you have a code for camshaft position sensor the issue is with the pulse generator in the ignition control module.
where is the crankshaft position sensor on 2.5 liter vw jetta
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
were is crankshaft sensor located in 2001 Saturn l300
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
its located next to a few nuts and blots
It is used by the PCM to determines fuel and spark timing
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
the position off the crankshaft sensor
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
Yes there is a crankshaft sensor
The 2003 Saturn L200 has a camshaft position sensor. It is located on the bottom front of engine behind the Starter. You will need to remove the two bolts that are holding the Starter to get to the sensor.
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
where is the crankshaft position sensor on a 2004 maxima
how to remove crankshaft position sensor from 91 Buick Regal
No, the 1983 model does not have a crankshaft position sensor. Only distributorless engine needs a crankshaft position sensor.
You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.
Yes they are the same.
The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.
CMP-camshaft position sensor CKP-crankshaft position sensor
Corvette didnt have a Crankshaft Position Sensor until 96.
Where is the crankshaft position sensor on a hyundai accent 2002