There are lots of mounting points on the deck. Pay attention to how they are taken off.
1. Remove the deck, by "rolling" the belt offf of the engine crankshaft pulley
2. Remove all the hold-down cotter pins (there should be 8), displace the deck from the 8 hangers, remove the deck from beneath the mower
3. Lift the mower to an upright position and secure (so it doesn't fall on you)
4. Remove the engine crankshft pulley, along with that end of the belt, by removing the crankshaft bolt (pay attention to how it comes off)
5. Unscrew the "Forward/ Reverse" knob, remove the plate beneath the knob to give access to the PTO pulley. (be sure to unplug the SAFETY device from the bottom of plate)
6. Remove the SNAP RING from the PTO pulley, and remove the pulley (pay attention how it comes off. Which belt where? MY pulley was a double pulley, of which one side "Floated")
7. Remove the clip (spring) from the Forward/ Reverse lever that is about half way down the shaft, and to the left of the pulley. Give it a twist and squeeze to the right. (This is tricky to put back on. PAY ATTENTION. The "U" part of the clip will go on the BACK side of the shaft when reinstalling. Then use pliers and/ or screwdriver to push the other part over the front side to catch the shaft)
8. Pull the tension pulley away and remove the rear drive belt.
GREASE ALL BEARINGS BEFORE PUTTING THE MOWER BACK TOGETHER!
In order to replace the drive belt on a 42 inch cut Murray riding lawn motor, first remove the blade after disconnecting the spark plug. The drive belt is now exposed for easy replacement.
no they drive them
Changing the deck belt on the Huskee IT4200 lawn mower involves working around the spring and 2 belt drive guides in the motor area. Properly loading the spring before the guides is the secret to success.
remove the varable speed pulley-replace both belts re-install varable speed pulley--your done.
Generally it is treated as being in the same category as farm equipment, so any place you can drive farm equipment you can drive a riding mower.
Huskee snow blower blows now good but needs help to move forward. Wheels do not spin in any situation.
You have to replace the whole drive shaft.
no
how do you replace the drive belts on an 1974 mercedes 230
how to replace drive belt 2003 Toyota matrix
Castlegarden
Not allowed to drive it in the highway or interstate