How do you replace the driver's side window motor in a 2000 Ford Expedition?
This is not an easy job. You need special tools to get the door panel off. I suggest you take it to the trim shop.
Actually you dont need special tools, all you have to do is remove 2 screws, one bolt and a long torx bolt.
Just remove the sail panel (covers the mirror bolts) and there is a screw behind it. pull out the switch panel and there is a screw behind it. pull the trim around the door handle and there is a bolt holding the door handle. and remove the light cover and there is a torx bolt in the light housing.
then lift straight up on the panel and once its loose, just unplug the light and it is off.
Window motor and regulator are found inside of the door panel and may be bolted or riveted in. Should be bolted. Disconnect the window from regulator, take out reg. and motor, then disconnect regulator from motor, reconnect new motor to regulator, reattach those inside of the door, then reconnect the window to the regulator, put it together and see if it works.
I have a 2000 oldsmobile and i had this problem with the drivers side. come to find out it was the switch and not the motor. If you check with a local junk yard you can pick up a good one for half the cost. I did replace the window motor but it still didnt work. i recommend the switch first then if that doesnt fix it then invest in teh window motor. save urself…
Purchase a Haynes Manual that is for your car. It will show illistrations as to what to take off and what not. To replace the drivers side window on a 1983 Z287 Camaro allow approximately six hours. Remove the inner door skin and remove the rivets that attach the motor to the door. Slide the window out of track and unbolt the vertical track. Unplug the harness and retrieve the assembly.
How do you replace the automatic window motor and regulator for the drivers side window on a 1994 Jeep Cherokee Sport?
What do you need to do to fix your driver side window on a 2001 Honda Accord LX the window is not off the track and the motor is running but the window will not go up?
How do you remove the driver's side door panel to replace the power window motor on a 1995 Cadillac eldorado?
The 1995 Cadillac Eldorado drivers side door panel is held in place by eight retaining clips. Pry outward on each retaining clip. The door panel will come off. Remove the linkage from the power window motor. Remove the wiring harness from the power window motor. Remove the retaining bolts. Reverse the process to install the new power window motor.
All you do is take off the door panel remove foam (plastic, rubber) weather guard & disconnect the wires for locks and window... remove speaker. There will be bolts (usually gold) . There are clamps holding the window to the regulator / motor loosen then pull window out through the top of door. When window is free just shimmy the regulator / motor out of the door on the bottom left side (there should be…