to replace it SIMPLY, set body on tall jack stands,keep the motor and trans in the body (not the frame) by using a ratcheting tie down to tie the trans to body, hold the engine up to the body by cherry picker or tie to rafters in garage,take front and rear diffs out,unbolt frame from body,(unhook wires and gas tank,and lines first) and roll frame out on floor jack. then reassymble with new frame. takes me about a day and a half to do one by myself. yes I have done a few. GOOD LUCK
because the plastic is liter than the metal
you must unbolt the frame from the body to be able to access 2 bolts
It would be cheaper to replace the frame unless the current frame is an antique.
gently insert a small flat head screwdriver on the left side of the bulb plate a push to the left.... the entire should bulb frame will shift to the left and then you can pull the frame out to replace the bulb....
you have to grind the welds that hold the frame rail to the rest of the frame and slide the ends out . replace the frame rails and weld it back.
frame the argument of the entire paper.
Yes.
The 08 Yamaha Raptor 700 frame can be used to replace the 06 Yamaha Raptor 700 with a little bit fabrication.
square the base frame and make sure base pieces are laid straight
Not a good question but replace the "frame with a stainless steel frame as a beginning and replace thegalvanesed pipe with copper or plastic.
there is no frame on a 95 monte, it's a unibody.
Cut through switching.