Brake Pads and Rotors
Plymouth Voyager
Grand Prix GTP
Grand Prix SE

How do you replace the front disc brake pads on a '94 Plymouth Grand Voyager?

Top Answer
User Avatar
Wiki User
Answered 2015-07-15 20:04:59

Replacing pads on the 94 is pretty simple. First loosen lug nuts on one wheel. Jack van up on side you loosened lugs on Finish removing lug nuts and wheel Put jack stand under vehicle in case jack falls.

Now, Remove the brake caliper by loosing the two nuts on the back side of the caliper. Mine were 1/2" head. Get somethign to set the caliper on to take tension off the hose and Slip the caliper off. Sometimes you have to tap it with hammer if rotor is worn in grooves. There is a spring clip you can undo just above where caliper sits ti helo make pads more free. Remove front brake pad by slipping in out forwards. I then usually remove the rotor which just pulls off to get to back pad becasue its hard to get off with rotor on. Rotor on this vehicle isn't part of studs jsut tap it in back to get it off. Slide back pad out forward. Take C clamp and push caliper piston back into cylinder. Put back pad on Put on rotot Put on front pad Clip spring back down Slide on caliper and put screws back in. Put wheel on and repeat for other side.

User Avatar

Your Answer

Still Have Questions?

Related Questions

How many brake lines on a 1999 Plymouth grand voyager?

After the proportioner valve, there is one for each wheel.

Where is the location of the brake light switch on 1993 Plymouth grand voyager?

Just above the brake pedal. The switch sets against the arm of the pedal.

How do you change the brakes on a 1997 Plymouth grand voyager?

You jack up and block the car. Remove wheel, Push brake piston in with a wedge against rotor, remove brake caliper. (two 10mm bolts) Take brake pads out and fit new ones in, - replace caliper, replace wheel.

How do you fix brake lights on a 1996 Plymouth Grand Voyager when the bulbs and fuses are good?

Replace the switch under the dash. First remove the cover, then find the switch mounted neer the brake pedel.Remove the wiring plug then disconect from the bracket.

Why are the brake lights not working in a 1998 Plymouth voyager?

try the brake switch on the back of the brake pedal

How do you replace the brake line on a grand am?

How do i replace brake lines on a 2000 grand am

Where is the brake light switch on 1997 Plymouth voyager?

It is just above the brake pedal. The switch rests against the brake pedal lever.

How do you change brake pads on a 1999 Plymouth Voyager?

Lift the car on a jack, remove the car tires, remove the brake shoe/calipers and remove the old brake pads. Properly dispose of the old pads, put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.

Brake drum diagram for 1997 Plymouth Voyager?

Sorry, we can not do diagrams. - See Haynes Manual.

What causes a brake light on the dash to stay on in a 1988 Plymouth Voyager?

Low brake fluid and the parking brake being on are the two most common causes.

Diagram rear brake 1993 Plymouth Voyager?

e-mail millerannap@hotmail.com I will send you Diagram

What would cause for no brake lights but tail lights work on 1997 Plymouth grand voyager?

Bad bulbs they are double filament or Bad stop light fuse or bad stop light switch

How do you remove the back hubs from a 1989 Plymouth Voyager?

remove the wheels, then the drums and brake sfoes. There are 4 bolts that hold the hubs onto the axel. Make sure to replace the shims if present when replacing it.

How do you replace the rear wheel brake shoes on a 1990 Plymouth voyager?

If you are new to doing drum brakes, then remove the drums on both rears and do one side while looking at the other side for reference.

Where do you add brake fluid for a 1998 Plymouth Voyager?

Under the hood, driver side, near the windshield you will see a small yellow cap. Brake fluid goes in there.

How can you change bad brake rotors on a 1999 Plymouth Voyager?

You jack up and block the car. Remove wheel, remove brake caliper. Rotor is now free.

How do you fit new brake rotors on a 1998 Plymouth Voyager?

You jack up and block the car. Remove wheel, remove brake caliper. Rotor is now free.

What kind of brake fluid goes in a Chrysler Grand Voyager?

With abs DOT 4 and without abs DOT 3 brake fluid.

Where do you add brake fluid on a 1998 Plymouth Voyager?

Pour into the master cylinder which is located on driver's side of engine compartment firewall.

Still have questions?

Trending Questions
What times 10 equals to 1000? Asked By Wiki User
How old is Danielle cohn? Asked By Wiki User
Unanswered Questions