0
How do you replace the front side turn signal lamp on a 2003 Trailblazer?
Wiki User
∙ 15y ago
Remove the headlight and then reach in and turn and pull out the side light socket. The headlight is held in place by two flat dagger pins. Pull them out with a flat blade screwdriver . One is on the top inside corner of the headlight assembly and the other is on the outside edge of the light assembly.
The light will then fall forward held in by the wires and allow easy access to the side marker sockets.
www.trailvoy.com All the aswers for your Trailblazer at our enthusiasts website!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Are Chevy Trailblazer 2003 front wheel drive?
No
What tools are required to replace front brake pads on a 2003 trailblazer?
to change brakes on a 2005 trailblazer do i need a star bit to remove cailber pins
How do you replace the cabin filter on a 2003 trailblazer?
it dose not have one.
How do you replace 2003 Chevy Trailblazer front bearing?
Get a Haynes repair manual. These vehicles are too complex to treat like old school vehicles.
How do know when to replace front tie rod on 2003 Chevy trailblazer?
Your steering linkage get loose. The swaybar end links are also a common failure
What is the estminated Cost for dealership to replace thermostat on 2003 trailblazer?
570
Will it be costly to replace the control panel in a 2003 Trailblazer for the heat and air buttons?
why would you do that?
What causes excessive road noise on a 2003 Chevy Trailblazer?
Front hubs my be wearing out.
What causes a 2003 Chevy Trailblazer to shake when you stop or hit the breaks...Ive given it a tune up already...so what else could be the problem?
replace the front brakes and rotors
How do you replace a front turn signal light on a 2003 ford excursion I have been told I have to drop the bumper. Is this correct Please help?
remove the two screws on the bottom of the turn signal and pull out
How do you replace turn signal flasher on a 2003 Saturn Vue?
how do you fix turn signal
2003 trailblazer making whistling noise toward center of engine?
it could be the idler puller rubbing on the bearings. we had to replace it on our 2006 Chevy trailblazer ext.
