Chevy Silverado
Lincoln Town Car
Door Panels and Handles

How do you replace the front top door hinge or hinge bolt on a 1994 Lincoln Town Car?

9899100

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:57:11
2015-07-15 19:57:11

Check this out. very easy job I replaced both pins; upper and lower on my 1994 Lincoln Town Car in less than an hour. The grinding the old pins in half took the longest.

http://www.lincolnsonline.com/tech/00045.html

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The temperature sending unit on a 1994 Lincoln Town Car is on the top front of the engine. It is directly in front of the distributor.

to replace hinge pins,u need to cut the hinge,then knock out the cut peices. u then install new bushings and pin that is available at any auto parts store. the replacement pins come with a c clip to make fture replacement easy

On the front of the engine in the middle of the engine block.

On a 1994 Lincoln Town Car : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle

Not unless you try to change the whole front end of the car.

On a 1994 Lincoln Continental , 3.8 litre V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver

i used to work for a Chevy dealer....if you already put new hinge pins and bushings in you now have to replace hinges that have to be welded in

It should be printed on a sticker in your trunk. I have a 1990 town car and the sticker is located on the right hinge when the trunk is opened.

Remove the passenger side wheel well liner and it's to your left, remove lines and replace.

It is necessary to state whether it is a 4X4 or a 4X2

Look ontop the radiator front middle. there should be a diagram sticker there.

Hope you have small hands and the right tools.

You need to disconnect the wiring to the electric window, locks, etc.,and the door has to be removed.The hardest part I think, is replacing the door spring that rides on the lower hinge; a body shop tool is needed for that.

A 1994 does not have a control module on the transfer case. But it does have a 4x4 Actuator on the front differential.

located in front of rear axecel passanger side

Under the hood above the right front (passenger side) tire.

front drive shaft, how do you get the yoke out of the transfore case to replace the ceal?

In order to replace the heater core, you have to go under the dash, passanger side. But before you go for it, you have to drain the coolant from the motor.

replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo 6 cylinder

Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.