answersLogoWhite

0


Best Answer

On some cars you open the hood, and the light socket will be right on the inside behind the fixture itself. A quarter turn counter clockwise and pull will remove the socket. Then push in while turning a quarter turn counter clockwise again will release the bulb, or on newer ones, you just pull them out as they are the spade type. On some cars you will have screws holding the lens assembly in, and it would have to be removed to replace the bulb. Then still on others, you would reach underneath the bumper.

User Avatar

Wiki User

โˆ™ 2015-07-15 20:55:30
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the front turn signal bulb located on a 1989 Dodge Dynasty?
Write your answer...
Submit
Related questions

Where is coil located on 1989 dodge dynasty?

Where is coil located on a 1989 dodge dynasty at


Where is the turn signal flasher located on a 92 dodge dynasty?

In the dash above the glove box/ashtray


Where is the water pump located on a 1988 Dodge Dynasty?

Its located in the gas tank.


Where is the blower motor relay on a 1988 dodge dynasty?

on the 89 dynasty, it is located right next to the thermostat


Where is the fuel pump for a 1991 dodge dynasty 3.3?

The fuel pump is located in the fuel tank, meaning you'll have to drop the tank in order to replace the pump.


How do you replace the turn signal bulbs on a 1997 Dodge Ram?

my left turn signal on my 1997 dodge conversion van works fine,the right signal lights but does not blink,,,,any ideas


Were do you locate the wiring harness from the fuel pump to the battery on a 1989 dodge dynasty?

The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.


Where is the computer located in a 1991 Dodge Dynasty?

The engine computer is behind the battery.


Where is the fuel filter located on a 1990 dodge dynasty?

The fuel filter is located behind the fuel tank.


Where is the turn signal flasher located on a 1999 Dodge Avenger ES?

The 1999 Dodge Avenger signal flasher relay switch is located beneath the drivers side dashboard. The signal flasher relay switch will be between the gas pedal and the brake pedal.


Where is the oil sending unit located on a 1991 dodge dynasty?

Next to the oil filter.


Where is the voltage regulator located on a 1988 dodge dynasty?

The engine computer is the voltage regulator.


Where is the turn signal flasher located in a 1994 Dodge Caravan?

On the steering wheel!


What does a 1989 dodge dynasty look like?

It looks like a1989 dodge dynasty! Go to your browser search, and type in pictures of 1989 Dodge dynasty and you will see what a 1989 Dodge dynasty looks like.


The Turn Signal and flashers on dont work ON MY 2000 Dodge Straus?

Replace the Flasher Relay.


Where is the location of a relay at for a 1989 dodge dynasty and if there is a picture?

What do you mean... A Dynasty has several Relays... they are located on the driver side of the car, on the inner fender.


How do you replace turn signal switch 1996 dodge caravan?

To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.


What does a 1996 dodge dynasty look like?

Dodge did not make a 1996 Dynasty. The last Dynasty was built in 1993.


Where is coolant fan sensor 1988 dodge dynasty?

The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.


Where is the turn signal flasher located on your 2001 Dodge Stratus?

under the dashboard on the driversside


Where is the turn signal flasher located on 1995 Dodge pick-up?

The turn signal flasher on a 1995 Dodge Pickup is located on the driver's side under the dash. It is right next to the fuse box above the brake pedal.


Where is the voltage regulator on a 1991 Dodge Dynasty?

The voltage regulator is located in the Single Board Engine Controller (SBEC or ECM). If you have to replace it, you have to replace the computer. The computer has the voltage regulator in it. The alternator gets feedback from the computer to produce more of less voltage.


Where is the fuel pump located on a 1989 Dodge Dynasty?

Within the fuel tank. Tank needs to be removed.


Where is the fuel pump located in a 1989 Dodge Dynasty?

# It inside the gas tank you got to drop the tank to get to it


Where is the blower motor located in dodge dynasty 1992?

Take out your glove box and a few trim and it will be in front of you