Ford Windstar
Chevy Beretta
Turn Signals and Hazard Lights
1995-2005 Chevy Cavaliers

How do you replace the front turn signal bulb located on a 1993 Chevy Beretta?

161718

Top Answer
User Avatar
Wiki User
Answered
2006-10-07 15:03:11
2006-10-07 15:03:11

It's a total pain in the ass! You have to lay down on the ground and reach up behind the inside of the bumper / spoiler / fascia (whatever you want to call it), and feel around for the plastic twist-grommet bulb-holder. Twist it 20 degrees counterclockwise (as though you were looking out through the lens) and withdraw the bulb-holder from the inside of the lens body. The wires should be long enough that replacing the bulb is a snap. But reaching up in there... well, you gotta have long, skinny arms and nimble fingers.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


how to replace a 1990 Chevy Beretta battery


The bulbs are located for the headlights under the hood of the car.


Pull the turn signal towards you, push it back to turn them off.


I am trying to find the 1988 chevy beretta computer module and where is it located?



lift the plastic cover twist the old bulb out unplug it reinstall


If you remove the headlight assembly you will have access to the turn signal bulb.


It is located inside the fuel tank. You need to drop the entire tank down to replace. in the bottom of the gas tank.


Go to autozone.com they have this information on their website.


Go to autozone.com. They have this information on their website.


The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.



How do you replace a turn signal bulb in a 1998 cavalier


there located behind the dash below the radio to the left of the ashtray. side by side,hazzard and turn signal





where is the freeze plug located on a 1992 Chevy beretta and I need a picture on it also


i need help on how to replace the pin in my 1989 Chevy beretta gt please help me


Bstuff.com should have the info you are looking for.


strt taking the dash apart under the steering colum. under there(behind the fuse panel ussally) is what would be called a flasher fuse they cost about 9.99 very simple to replace. i just had to do it in my beretta. it was funny because the hazard lights would work but not the turn signals. I also ran into a problem with the wiring for the turn signals were the bulbs plug in. I had to replace the pigtail conectors also.


The turn signal flasher on a 2008 Chevy Avalanche is located inside a panel close to the gas pedal.


The voltage regulator is built into the alternator.


Professionally, it will cost around $2,000 to replace a broken shifter and clutch in a 96' Chevy Beretta. Just the replacement clutch and shifter will end up costing you around $800.00.


Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.