answersLogoWhite

0


Best Answer

Begin by removing the wiring harness from your 1983 Volvo 240 turn signal lamp. Remove the turn signal lamp assembly retaining bolts. The turn signal lamp assembly will come out. Reverse the process to install the new turn signal lamp assembly.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

15y ago

Just had to do this. At the top outside edge of the headlight assembly, where it meets the turn signal assembly, there is a space you can put a finger through and push down a plastic tab. It's not hard to see if you know it is there. With the tab pushed down, the whole turn signal assembly can be pulled forward and out.

This answer is:
User Avatar

User Avatar

Wiki User

9y ago

A headlight bulb on a 1982 Volvo 240 is accessed through the engine bay. Lift the hood and safely prop it open. Locate the headlight housings and pull the old bulbs off. Install the new lights.

This answer is:
User Avatar

User Avatar

Wiki User

9y ago

The taillights on a Volvo S80 are accessed through the trunk of the chassis. Remove the plastic covers from the rear of the car then twist of the old lights. Replace with new bulbs

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the front turn signal indicator assembly on a 1999 S70?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a front turn signal on a Volvo s40 2001?

Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.


How do you replace a front indicator bulb in a Saab 9 3?

How do you replace a front indicator bulb in a Saab 93


How do you replace the front turn signal on a 2001 2dr sunfire not a part of the headlight assembly?

It looks as if I'll have to crawl under the front of the car to access the bulb to replace it.


How do you replace the front turn signal bulb located on a 1998 Chevy S-10?

The front turn signal assembly will pop out with a little help. It is held in place by clips that snap it into place.


How do you remove the front lamp assembly on a Lexus RX300 to replace the left turn signal bulb?

look in your owner's manual


99 cavalier right front turn signal replacement?

Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.


How to replace the front right side turn signal assembly for a 1985 Lincoln Continental?

i need to replace a throttle sensor and put a throttle body rebuild kit in


How do you replace the front turn signal light bulb on a 1996 Saturn SC2?

rear you use a torx driver to remove taillight assembly screws. them replace bulb.


How do you replace the front turn signal bulb located on a 2002 Buick Park Avenue?

Remove headlight assembly to access bulb/socket.


How do you replace turn signal light on a 2002 Oldsmobile intrigue?

Unplug the whole light assembly from the bottom front of the car it just pops out to replace the turn signal bulb-same on the rear but you have to remove the trunk lining first.


How do you replace the front turn signal bulb located on a 1999 Chevy Blazer S-10?

Remove the headlight assembly above the faulty signal bulb. This will give you access to the signal bulb socket. To remove the headlight assembly, open the hood, stand in front of the headlight assembly, notice two black tabs sticking up behind the headlight assembly inside the radiator support. Pull up and wiggle the tabs to remove them, this will release the headlight assembly. You can now wiggle the headlight assembly out to gain access to the signal bulb socket for replacement.


How do you replace turn signal switch 1996 dodge caravan?

To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.