located in front of rear axecel passanger side
Usually underneath near the back axle.
you have to take the gas tank off to get to it and if you need to replace the fuel filter they have to be spechial orderd.
where do i find the thermostat for 99 cavalier
The Chevy Cavalier does have a fresh air intake filter. The fresh air intake filter is located behind the passenger side kick plate.
Replace the spark plugs and the spark plug wires. Replace the air filter. Replace the oil and oil filter. Replace the fuel filter.
The oil filter is located on the passenger side of the engine I got at mine from the top of the car and found it easiest to replace it from there. It is down middle of the engine.
The fuel filter is located just above the rear axle.
It is located right above the rear axle.
Behind the gas tank.
in the fuel tank
The oil filter is located at the back of the engine, under the power steering pump.
It is located behind the gas tank in the rear of the car.
look in front of the gas tank
How do you remove and replace wiper switch on 2002 Chevy Cavalier
Its locate in the down right side of the motor,is a AC-PF47 filter.
A 2000 Chevy Cavalier does not have a cabin air filter. These standard vehicles came with an engine air filter located under the hood of the vehicle, in the air box.
Where is the stater located on a Chevy Cavalier located?
Located in rear of engine under intake manifold , left side of engine
Replace the fuel filter, that is a good place to start.
its on the passerger side by the front wheel under the power steering.
Where is radiator temperature sensor located on a 1997 2.4L Chevy cavalier
On a Cavalier 05, with an Ecotec 2.2L the oil filter is at the front of the engine, from above, to the right. It's a black cap that can be opened with a 1 1/4 inch socket wrench, with extender. The filter snaps onto the bottom of the black cap with the point on the filter facing down. The black cap will be facing up at you. Most newer Chevy Cavalier's have a paper oil filter, located on the TOP of the engine normaly on the driver's side.
Just did it on my 94RS its simple, its in line under car just in front of rear axl, tools used were 2 wrenches and needlenose plyers.