Best Answer

my cluch is lost pressure and the geare doest notwork even i have change the valve onbelow

User Avatar

Wiki User

โˆ™ 2009-07-25 14:22:15
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the gear selector cable on a 1995 Mazda Protege?
Write your answer...

Related Questions

How do you replace the cable in the driver side window on a 2001 Mazda protege?

The cable cannot be replaced. Roger (AKA as Einstein by his many friends) said to remove the panel, drill out the rivets and replace the unit.

02 Mazda pro 5 e brake cable loose?


Where is speedometer cable on a 2000 Mazda Protege DX?

My guess would be that there isn't any speedometer cable, it is probably electronic.

How do you connect the positive battery cable to the starter on a 1998 Mazda Protege?

There are two posts on the starter solenoid when the starter is in position the top one is for the positive battery cable. The bottom one should have a very short cable that enters the starter casing. I just replaced the starter in my 98 mazda protege yesterday.

How do you replace a battery in a 2003 protege 5?

Disconnect the negative cable FIRST!..then disconnect the positive and remove.

How do you check the manual transmission fluid on a 1992 Mazda protege lx?

You have to disconnect the speedometer cable to check it. There are no marks but halfway up the gear is where the fluid should be. Then pump fluid into it if its low.

Selector only stays on defrosted 92 buick?

If the heat selector will not switch from defrost to the dash or foot vents on a 1992 Buick, it is possible that the cable connected to the vent is broken. When the selector is moved from defrost, a cable opens the other selected vents on the heater.

How do you repair an AT selector cable on a 1990 Honda Accord 2.2 LX?

No repairing the cable. Replacement is the only option.

How do you replace the speedometer cable in a Mazda 3?

locating speed detecting pinout ,as to fit a speed alert to a 2004sp23 auto mazda3

How do you open a stuck fuel door on a 2000 Mazda Protege?

The fuel door release tab is seized you need to replace just that release tab only it unbolts from the gas cap compartment... Open up the trunk pull back the fake wall you will see the release cable attached to the release tab...very easy fix...

Replace clutch cable on a sportbike?

Replace clutch cable on sportsbike

Mazda mx3 the rpms are out of control they go higher and higher as you drive and will not settle down even at a stop?

Have a certified mechanic replace your throttle cable!

Why won't a 94 Mazda Protege start over or do anything if the battery and starter were checked and they are good?

AnswerCheck or replace the battery cable. AnswerIs the ignition switch bad? Is the neutral safety switch bad (automatic)? Is the clutch pedal switch bad (manual transmission)? Is the wiring in good shape?CHECK YOUR MAIN RELAY FUSE UNDER THE HOOD (DOUG )

How do you adjust the shifter detent in a th350?

If the transmission shift selector is cable operated, the adjustment would be located at the transmission end of the cable, where the cable housing is attached to the bracket on the transmission.

How to replace 95 f250 speedo cable?

How to replace spedo cable f250

Why is the gear shift cable on the 2000 Saturn SL a two cable system and should it cost 300 to fix it at an auto shop?

It uses two cables because one cable is used to pull the gear selector toward Low and the other cable is to pull the gear selector toward Park. If one is bad, you should always replace both. It's expensive because they are somewhat annoying and time consuming to get to, and each cable costs typically over $40. You really shouldn't expect to get out of a shop for under $200 labor, so it's about right.

How do you change clutch cable on 1995 Mazda miata?

there is no cable, it is a hydraulic system and you probably just need a new slave cylinder or a master cylinder. Both are easy to replace. it could be that you just need fluid in the resovior.....

Mazda b2500 tach works speedometer does not?

The Mazda tachometer and the speedometer have separate cables. The tachometer cable probably does not work properly. Change the tachometer cable.

How many cable channels in 1981?

Usually up to 36 channels using a Jerrold cable box, which had twelve buttons and a three-position selector.

How do you replace throttle cable on grizzly 600?

how to replace throttle cable on grizzly 600

What would cause a 1991 Mazda Protege to have a blinking hold light and a non-functional speedometer?

The speedometer cable (which runs from the transmission to the dashboard) has snapped. This is a two-piece cable, and the one-piece cable in later Proteges will not work. I had the transmission replaced, and the cable could never be fit in properly. This is a mechanical speedometer, so you would have to change the entire speedometer part of the instrument panel to use a magnetic/electronic speedometer.

How do you replace the alternator on a 1991 Mazda Protege?

remove neg cable remove sensor that is located on top of alternator, move to one side still connected. remove power and reg cables on alt. loosen tension bolt remove bolt at bottom of alt. can do it from top behind alt. rewmove tension bolt and belt,work altr loose thru top between gas line and sensor that you moved, replace the same way

How do you replace a corroded battery clamp?

Either replace entire cable or cut off with a hacksaw and replace cable end

How do you replace the climate control cable on a 78 corvette?

One end is attached to your control selector mounted in the console. the other end is connected to a bracket next to the air vacuum cut off switch. This switch is located behind the glove box, which has to be removed. If you take off the passenger side console side cover you will see the adjuster for the cable and see where it connects to the selector. You have to remove the center section console to get underneath to disconnect it........

How to Replace speedometer cable 1989 Toyota truck?

Speedometer cable replace 1989 toyota