You need to take off the trim piece that goes across the entire dash. There are spring clips on the passanger side and a few screws around the IP panel you need to take out. the dimmer switch & hazzard switch both have clips on the back that need to be lifted before it will push thru (or just disconnect the electrical connector. the ac vents will stay attached to the trim piece. don't pull it too far forward theres not much play in the wiring harness.
please give instructions on replacing the ignition switch on my 99 Malibu
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
You should be able to pry the front button of the hazard switch. Underneath (looking from the floor view) there should be a hole/cutout for a standard screwdriver to access. The switch is behind the button. (per my haynes manual) Hope this helps. DC
there is not exactly a flasher relay for this car. technically your hazard switch is the flasher relay. you can get this "hazard switch " for about $30 on gmpartsdirect.com. i had to replace mine last year and i was also under the impression that i needed a flasher relay since the turn signal would just stay on. I had to fudge around with hazard switch push it a few time for the signals to work. that is when i figured it out that hazard switch is the flasher relay. i hope this helps.
The turn signals operate through the Hazard switch. The Hazard switch assembly is in the radio console inside the car and must be replaced. This unit is about $90 CDN and can be purchased from the dealership. I replaced mine by pulling out (Carefully!) the radio console (the owners manual will show you how to do this). After that, you: Push the old Hazard Switch out from the rear of the radio console. Unplug the wire at the end of the broken Hazard switch. Plug the wire into the new Hazard switch. Push the Hazard switch back into the radio console and slide the radio console back in place. It takes 2 minutes if you get someone to hold the radio unit while you change the switch. Good luck!
you can find the switch on the back of the brake pedal.
The cylinder should not be worn out on a 99 car unless you were using a very heavy key chain. I would just replace the ignition switch if the cylinder works OK. You also might try some Graphite lube on the cylinder.
i have a leak in power steering lines on 99 Malibu . show me line schematics
Yes, there are bleeder valves for cooling systems for 99 Malibu.
The interior bulbs on a 1999 Chevy Malibu are contained in a plastic fixture whose cover snaps open. Once inside the fixture, pop out the dead bulb and replace it with the appropriate replacement.
Maybe a one piece module located behind the hazard switch if located in dash
To check the fan relays on the 99 Malibu, you can swap the relay between the AC blower and the fan.
Had the same problem my self last week. Take a hot wire and a ground and jump out the switch. Changes are the master switch went bad on the door panel. Ken
marks timing chain 99 Malibu 2.4
i have a 99 Malibu and it takes about 5 and a half quarts to fill!! hope this helps!!!i have a 99 Malibu and it takes about 5 and a half quarts! hope this helps!!
Occasionally my 200 Malibu does something similar...engine turns off, but radio stays on, etc. Make sure you a really in PARK to get the accessories to turn off.
Were is locate the snock sensor of chevi malibu 99
Yes. '97-'05 the same.
I am 99% positive that your Malibu does not have a cam belt, but instead has a cam chain. Look in your owner's manual or call your local Chevy dealer to be 100% sure.
replace the head light switch
fuses are ok. replaced ignition multifunction switch and hazard, turn signal, cruise etc. switch. checked grounds. hazard lights when ignition is off but not in the on position. thanks Joe lapointe
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.
turn signal switch needs replaced!
If they are both V6, then yes. '97-'99 all the same.
1999 Chevrolet Malibu, Curb weight, 3,055 to 3,077 lbs.