0
Add your answer:
Earn +20 pts
How do you fix a valvecover gasket in an 1994 Buick LaSabre?
Replace the gasket.
How do you replace the thermostat located on a 1994 Chevy Cavalier?
where do i find the thermostat for 99 cavalier
How can you change transmission fluid in a 1994 Chevy Astro?
Drop the lower transmission pan Clean pan Replace filter and gasket
How do you replace fuel filter on 1994 Chevy cavalier?
located in front of rear axecel passanger side
How do you replace the blower motor on a 1994 Chevy lumina euro?
How do you replace the blower motor on a 1994 chevy lumina euro?
How do you replace the thermostat located on a 1994 Chevy Impala?
The thermostat is located in the thermostat housing at the engine end of the top radiator hose.
How do you replace the head gasket located on a 1994 Chevy Corsica?
Hey Richard==It is quite involved but if you want to try it get a manual on your car. It will have pictures and everything. GoodluckJoe Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
How do you replace the head gasket located on a 1994 Oldsmobile Cutlass?
What size engine? 3.1 or 3100? yes there is a difference. j1taylor@twcny.rr.com
How do you repair a head gasket 1994 Chevy G20 van?
You will need to remove the cylinder head from your 1994 Chevy. Remove the head gasket and clean the surface. Put the new head gasket on and put the cylinder head back to its original position.
Where is the thermostat located and how do you replace it located on a 1994 Chevy Astro?
Its at the base of the upper radiator hose, under the outlet. Drain some coolant out before removing this if you don't want a mess. Make sure all old gasket is clean before putting a new one in.
How much will it cost to replace a head gasket on a 1994 Chevrolet Suburban?
1500
How do you replace the head gasket located on a 1994 Oldsmobile Cutlass 3.4L?
To replace the head gasket on a 1994 Oldsmobile Cutlass 3.4L, everything on the top of the motor needs to be removed. The battery should be unhooked first, then the valve covers, then the head itself. Replace the new gasket after cleaning the old gunk off from the first gasket. It is a good idea to take a picture before, during, and after, to make sure everything is hooked up like it should be. One note, the valve cover gasket will also have to be replaced after removal.
