Audi A4

How do you replace the headlight bulb located on a 2003 Audi A4 Cabriolet?

686970

Top Answer
User Avatar
Wiki User
Answered
2005-10-19 08:31:23
2005-10-19 08:31:23

For an Audi A4 year 2001-2005: There are 4 screws that hold the head light unit in place, you need to remove the complete unit to gain access to the bulbs. 1. you will have to mask off the bumper under the head light first, this will stop you damaging the paintwork. 2. you now have to pull off the electrical connector block this is done by squeezing the small bridge on the side of the block. 3. remove the top 2 screws completely, then slacking off the bottom 2 screws but don't remove them. 4. now slowly pull the head light unit out being careful not to damage the paintwork. 5. lay the unit on a towel to stop it from damaging whilst you unclip the back cover, these bulbs are H7 55 watt. 6. replace bulb and reinstall same as removal. job done.

001
🙏
0
🤨
0
😮
0
😂
0

Related Questions


How do you replace 2003 nissan maxima headlight?

how do i replace the drivers side headlight in a 2003 oldsmobile silhoutte

“how to replace headlight bulb 2003 park ave”

Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.

If its anything like my 04 sonoma, there should be two flat pins which hold the headlight assembly in place. the pins come out, the socket for the bulbs become acessible. twist out and replace. .

if its like my truck you have to take the grill and the whole headlight assembly out to replace it good luck

The headlight assembly, on your 2003 Toyota, can be accessed from the engine compartment. Remove the retaining bolts. Unhook the wiring harness. The headlight assembly should come out.

To replace the headlight assembly on on 03 Jetta, the grill and front bumper have to be removed before you can get to the screws below the lamp.

take it to the dealer and let them do it

How do you replace the fog light located on a 2003 Ford Expedition?

Take a hammer. smash the headlight assy. lens. Remove old bulb, put in new.

you have to remove the screws from the top of your bumper and remove the screws from the front of the wheel well bumper should slide forward then remove two bolts on top of headlight then remove bolt under headlight then housing should come right out

How do you replace the fuel filter on a 2003 Buick Regal?

how to change a headlight on a 2003 passat

behind the passenger side headlight

Not enough info. Please reask question with year, make, and model.

I need to replace the bulb on the driver side of my 2003 Dodge Grand Caravan. After searching this forum I found a similar question regarding the 2000 Caravan. It talked about under the hood removing three screws and pulling out the headlight assembly. I tried this and it worked on the 2003. 1) open the hood. 2) Carefully remove the three screws holding the headlight assembly in place. In my case the screws were black. Be careful as they are screwed into plastic. 3) Carefully slide the headlight assembly out. At this point you can replace the headlight bulb, turn signal bulb, or the entire headlight assembly. To replace the headlight bulb turn the collar holding the bulb in counter clockwise. Pull the bulb out of the headlight assembly. Replace the bulb. Insert the bulb into the headlight assembly insert the collar and turn clockwise until it locks. 4) Carefully insert the headlight assembly back into place. 5) Replace the three screws removed in step 2 being carefull not to over tighten.

1) open the hood. 2) Carefully remove the three screws holding the headlight assembly in place. In my case the screws were black. Be careful as they are screwed into plastic. 3) Carefully slide the headlight assembly out. At this point you can replace the headlight bulb, turn signal bulb, or the entire headlight assembly. To replace the headlight bulb turn the collar holding the bulb in counter clockwise. Pull the bulb out of the headlight assembly. Replace the bulb. Insert the bulb into the headlight assembly insert the collar and turn clockwise until it locks. 4) Carefully insert the headlight assembly back into place. 5) Replace the three screws removed in step 2 being carefull not to over tighten.

how to replace the crankshaft position sensor located in a 2003 kia rio

We have a how to with pictures at our enthusiasts website! www.trailvoy.com

what causes 2003 corvette headlight to not go down


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.