To replace the heater core on the 83-87 Prelude with A/C The center console and the upper dash will be removed, This is not a job for the novice.If you have a Prelude without A/C the heater core can be removed simply by removeing the heater control valve which is under the hood behind the engine against the firewall, Then under the dash you will find the hose connections to the heater core entering thru the firewall, remove the clamps from the hoses, remove the t-bracket retaining screw and bracket that hold the heater core tubes to the control box, remove the screws that retain the heater core hose cover then slide the heater core from the control box and reinstall in reverse order.You can view a picture of the unit at [url]http://www.slhondaparts.com/browse.asp?Model=PRELUDE&Year=1985&TrimLevel=2DR+DX&TransLevel=5MTKL&Section=E&Category=B++1702%7CHEATER+UNIT&Doors=2&Emissions=KL&PartCatalogId=13SB00&ViewParts=true [/url] this link is for an 85 but they are basically the same.
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
The 1986 Honda prelude 2.0 Si has a A20a3.
my Honda prelude 1986 si wants to cut off after its warmed up . any sugestions on what ot could be
nIG JOB. gET A MANUAL ON YOUR CAR AND DO THE JOB CORRECTLY.
is inside the alternater
inside the trunk?
You need to replace the entire headlight. Only remove the screws that hold the trim in place. Don't back out the adjustment screws.
On the crossbars of the steering wheel.
Make sure your computer has no viruses
the dashes are pretty similar but some of the plugs are different.
Programed Fuel Injection
They do if it is an automatic transmission. The Prelude (except Si) has the same manual transmission as well. The Prelude Si has a slightly different manual transmission, but it will still fit into a 1986-1989 Accord.
its like my 91 Prelude 5 speed transmission is stuck in 2 gears.It is wielded.
the best swap would be a JDM vtec 2.2 liter. you can get a 2.2 liter vtec out of something like a 2001 Honda prelude but you would have to do the wiring harness
Most vehicle manufacturers now put the regulator inside the alternator.
This is the most gramatically incorrect question ever, but I belive the Corlolla is faster on a racetrack.
What is the problem? Do you want to replace fan or fan clutch?
Yes Actually they can have either. The "S" models are carbs. The "Si" models are fuel injected.
add an air intake and full exhaust system if you havent yet done that
on top of oil filter plate it has one wire
Not practical to try to fix a heater core. Replace it with a new one.
The computer on a 1986 Honda Prelude Si can be upgraded but the harness will need to be updated as well. This is done using a wire harness conversion kit. The kit will allow for a tunable ECU.
The alternator on a 1986 Honda Civic is located in front of the engine. Unplug the battery and remove the alternator belt. Loosen the alternator bracket and remove the plug to the alternator. Replace the unit.
86 prelude pcv locationThe 1986 1987 Honda prelude pcv valve is in the middle under the intake. It has a hose running through an opening on the intake. It is only accessible by removing the intake. The intake is very hard to remove in the carbecause the bottom bolts are so hard to get to.