answersLogoWhite

0


Best Answer
Copy

it is in the middle of the car inside thedash area on the very bottem of the coverd areA back by the foot area you need 7mm and alot of time about 2 hours to change it

User Avatar

Wiki User

โˆ™ 2015-07-15 20:01:41
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the heater core in your 1998 Olds Intrigue?
Write your answer...
Submit

Related Questions

Cost to replace O2 Sensor in 1998 Olds Intrigue?

$300 with labor


How do you change 1998 Olds Intrigue?

Change what?Change what?


1999 Oldsmobile Intrigue Service engin soon?

What does 'service engine soon' light mean on a 1998 olds intrigue?


How do you replace a heater core on a 93 olds 98?

how do you replace a heater core in a 91 Oldsmobile 98


How do you fix a burned out radio light on a 1999 olds intrigue?

Replace the radio.


How do you replace the windshield wiper motor on 1998 olds intrigue?

Should be able to access under hood at center firewall plastic panel may have to be removed


Why did the air conditioning in my 99 intrigue start blowing hot air?

Olds intrigues have a habit of the heater/a.c. control head going bad. It will set you back about $600 to replace it.


How do you replace a starter on a 1998 olds cutlass?

how do you replace a starter on a 1998 cutlass


Where is the Location of the Engine Control Module For a 1998 Olds Intrigue?

Behind the glove compartment.


What other vehicles are interchangeable with 1998 Oldsmobile intrigue?

Most parts on the 1998 through 2002 Olds Intrigues are interchangeable.


How do you replace motor mounts on olds intrigue?

If you have some vehicle repair knowledge you can replace them yourself. If not, it is best to have a mechanic look at it.


Where is the computer in a 1998 Olds Intrigue?

In the right kick panel. On my 98 Intrigue it's it the engine compartment in the black box connected to the air filter.


How to replace heater core in a 1996 olds achieva sl?

To replace most heater cores you have to remove the dash on the passenger side.


How do you repair power window on 98 olds intrigue?

To repair the power window on the 1998 Old Intrigue, you will first need to remove the interior door panel to access the window motor, switch, and actuator. You can then determine which part is broken or damaged and replace that part.


How do you replace a 2001 Olds intrigue cabin filter?

it should be under the cowl on the pass side of the car


How do you replace the throttle position sensor in a 98 Olds intrigue?

The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.


What is a ac control head on a 99 olds intrigue?

The AC control head is the control panel for the heater/air conditioning in the vehicle.


How do you replace the oil pump on a 1998 Olds Bravada?

== ==


Why does your heater occasionally stop working and there is water on the floorboards on a 95 olds achieva?

you need to replace your heater core.


1998 olds intrigue Blower motor does not work in low?

Either it's the switch on the dash (unlikely) or the blower motor resistor pack (very likely). The resistor pack is usually easy to replace.


Leak in your 1999 Oldsmobile intrigue can you use stop leakCan you use Stop leak for a radiator leak in a olds intrigue 1999?

where is it leaking from? I have a 1998 intrigue and in was my heater hose fitting, which is about 4 dollars, just not a fun part to hange it tok me about 2 hours to do it.. it is connected to your tensor pulley, it is a lil black plastic l shaped piece.. if u have any more question.. repost..


Where is the camshaft sensor in 99 Olds intrigue?

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.


2000 olds intrigue constantly overheats?

you might need a thermastat. my 98 was doing the same thing. its easy and cheap to replace.


Can you skip removing the PS Pulley and just remove the entire pump to access the WP Bolt?

This is on a 1998 Olds. Intrigue 3800 V6


1999 Olds Intrigue stalls when at idle sometimes. rpm jumps or stalls when I put it in reverse Runs great when my foot is on the gas over 1000 RPM. What is going on here?

I have a 1998 olds Intrigue and mine started doing that it was the crank shaft position sensor