Remove air box, pulley is located just under attached to engine block. Should remove bolts take off belt, and replace pulley and belt.
You can relieve the tension on your 1994 Mitsubishi Gallant belt by loosening the tensioner pulley. The tensioner pulley can be loosened by turning the retaining bolt to the left.
Try to replace only bearing #6203 2Z inside of pulley.
You can remove your 1993 Mitsubishi alternator belt by loosening the tensioner pulley. Slide the tensioner pulley to the right. The alternator belt will become loose and can be removed. Reverse the process to put the new alternator belt on.
The firing order for a Mitsubishi 1.8 liter engine is 1, 3, 4, 2. The number one cylinder is on the left side, closest to the engine pulley.
Belt tensioner? Idler pulley?
Begin by loosening the tensioner pulley on your 1999 Mitsubishi Eclipse. The alternator belt will become loose and can be removed. Put the new alternator belt on and tighten the tensioner pulley.
One is on the crankshaft pulley the other is on the camshaft pulley.
I'm not real sure i understand the question.the question alludes to a "drive" (as in transaxle) mechanism requiring a "drive" belt. Referring to serpentine "drive" (pulley) belts for alternator, power steering and water pump:most cases require you to loosen the alternator adjusting (tightening) bolt and/or the power steering pump adjusting bolts. I had to replace a broken alternator belt a few weeks ago in 15* weather (outside). I had to use a "push" tool to force the beltbetween the pulley on the alt. And the other pulleys to get over the crank pulley.
You will need to loosen the tensioner pulley in order to create slack in the serpentine belt. The belt will come off with the tensioner pulley loose. Reverse the process to install the new serpentine belt.
No, you do not need. Just remove all bolts and pull it out. Make sure that you replace the water pump gasket.
The tension pulley is centerline with the engine and at the very top of the belt routing.
The cylinder. Positions are marked on the main front pulley. Manually turning the pulley to the number one position and the number one cylinder will be in position.
The tension pulley should have a bolt that holds it on, allowing you to replace the unit.
The Mitsubishi 2.4 liter engine timing marks can be found on the front of the main pulley. The timing marks will be scattered around the outside of the main pulley.
The 1988 Mitsubishi 2.0 liter engine timing marks can be found on the front main pulley. The timing marks will be scattered around the outside of the pulley.
Remove the old, damaged idler pulley and replace it with a new one.
The timing marks, on your Mitsubishi engine, can be found on the front main pulley. The timing marks will be on the outside edge of the pulley.
replace the pump
replace 1996 nissan 200sx se 1.6 tension pulley
#3 is third cylinder from the pulley end of engine.
It's behind the timing belt. Even so you do not need to remove the belt, you will have to remove the pulley and covers. If you want to replace it.
my husband just did so. the pulley is part of the air condition compressor, so you have to replace the whole part that's connected to the pulley, you can'tjust replace the pulley it self, and going to the junk yard for these partsis very cheap and the way to go.