answersLogoWhite

0

  • Chevy Camaro
  • Ford Explorer XLT
  • Chevy Camaro Z28

How do you replace the ignition control module on a 1983 Z28 camaro with Cross Fire Injection?

User Avatar

Wiki User

βˆ™ 2008-03-03 19:26:36

Best Answer
Copy

you remove the distributor cap and the module should be underneath make sure you get the right one there are 5 prong and 7 prong modules also make sure you put the heat dispursing grease on very thick this will keep it from over heating and rendering your car usless for about 5-10 hours

2008-03-03 19:26:36
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where can you replace the ignition key to your 1990 Chevy Camaro?

the ignition keys are dealer only items.


How can I replace the lost ignition key on my 1983 camaro?

You will more than likely have to get a new ignition and key for it.


How do you replace an ignition switch on an 1989 camaro?

switch itself or key cylinder?


Why your Camaro shuts off after warming up?

Check the ignition control module and the coil


How do you replace the ignition switch on an 84 camaro z28?

I don't know thats way I ask


Why does your ignition turn the wrong way on your 1979 camaro can not get the ignition to turn forward only back. can not start?

Replace the tumbler assembly, it is broken.


How do you change the ignition switch in a 1988 Chevy Camaro?

How do i change the ignition switch in a 1988 Chevy camaro


When did the Camaro switch to fuel injection?

Chevy swtitched some of Camaros to fuel injection in the mid 1980's. By 1988 every Camaro engine came with Fuel injection.


What is the cause for no ignition in a 87 iroc z28 camaro?

bad coil, bad ignition control, bad ecu, blown fuse and or switch need more info


What electrical problems cause 1987 camaro not to start?

dead battery, or a bad ignition control module inside the distribureator.


Does a 1980 Chevy Camaro have a computer in it?

No, a computer controlled Camaro did not come around until 82, with the Crossfire Injection.


How do you change the ignition switch on a 1997 Chevy Camaro?

You will need to remove the retaining ring from the top of your 1997 Chevy Camaro ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.


Where is the fule filter located on a 97 Camaro?

where is the main fuel filter located on a 1997 Camaro rs with fuel injection


How do you replace a power window switch for a 1993 Chevrolet camaro?

pry out the control switch and disconnect the electrical connectors.install is reverse.


How do you replace a water pump on a 1996 Chevy Camaro z28?

How can do I replace a water pump on a 96 camaro z28


How do you change a ignition switch on a 2001 Chevrolet Camaro?

The 2001 Chevrolet Camaro ignition switch is held in place with a retaining ring. Remove the retaining the ring and slide the ignition switch out. Remove the wiring harness. Reverse the process to install the new ignition switch.


Can you replace a 2001 Camaro windshield with one from a 1995 Camaro?

Yes, you can use a windshield from a 1993 and up Camaro for your 2001 Camaro.


My 1998 Chevrolet Camaro ignition key is stuck in on position does anyone know how to repair or remove key?

Replace the ignition. That would involve tearing down the column a little bit. A very common thing seen by a locksmith.


What is causing the security light to come on and the car won't start on 95 camaro?

it means your ignition tumbler is bad. you need to replace it and have the dealership make a replacement key.


Where is the ignition module on a 1980 Chevrolet Camaro?

It is inside the distributor.


GM scanner found code 43 on 1989 Camaro referring to Electronic spark timing ESC circuit - low voltage detected or Electronic spark control circuit problems what and where is this and how to fix it?

replace the ignition module Its under the rotor inside the distributer cap


What color wire is the ignition switch on a 1969 camaro?

purple is the trigger wire for the starter. Yellow is the ignition wire.


What is the ignition timing for a 1991 Chevy Camaro RS?

8 degrees


Where is the ignition module located on a 1980 Chevrolet Camaro?

It is inside of the distributor.


Where is the ignition module located on a 1980 Chevy Camaro?

It is inside the distributor