For a 1988 Mercury Marquis remove bottom shroud from steering column (5 Philips head screws). There is a wire running from the ignition switch to the left side of the steering column; detach it from the coupler (This can be done without a tool). Turn key to ON position until the panel lights come on. There is a small pin near the bottom of the key lock; push it in and pull the ignition switch out (don't panic if the wire seems to be stuck; it will come out).
To replace, turn new ignition switch to same position. Push pin on the ignition switch in while sliding it back into the steering column. Reconnect wire and then replace shroud.
To replace the ignition fuse on a 1995 Mercury Villager, use a fuse puller to remove the appropriate fuse. Then replace broken fuse with one of the same amperage.
Remove the wiring harness from your 1999 Mercury Grand Marquis ignition coil. Remove the ignition coil retaining screws. Reverse the process to install your new ignition coil.
You will have to look in the glove box for the owners manual and look it up.
How do you replace the timing chain on a 1994 mercury grand marquis
how to replace starter on 2000 mercury grand marquis
At least $75
It's located on the steering column 2 screws unplug the harnest
how do you get to and replace the wiper moter on a 97 marquis
where is the ignition control module located on mercury marquis
how do you replace the front sway bar likn in a 1999 Grand Marquis?
pre-heat spark plug, if this works then replace it.
how to change igntion lock
Mercury Grand Marquis was created in 1983.
take it to the dealer
change wiper motor grand marques