Quantcast
answersLogoWhite
notificationBell

Top Answer
User Avatar
Wiki User
Answered 2014-09-18 00:23:23

The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.

012
๐Ÿ™๐Ÿฟ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

Why is there no fire going to the distributor on my 1992 Plymouth Colt?

Check the ignition coil or the "pick up" located inside the distributor


Where is fuel relay switch on 1990 Plymouth colt?

i have a 91 hatch back mine is located directly below the radio on the floorboard


Where is the starter in a 1993 Plymouth Colt?

The starter on the 1993 Plymouth Colt is mounted on the back side of the engine (by the firewall), and below the intake manifold.


Is there a points distributor that would replace the electronic ignition in a 90 colt 1.4?

No there is no points distributor for that year. Courtesy of the Garage Guru Consultant.


Where is a ignition module located on a 1993 dodge colt?

where is a ignitionmodule in a dodge colt a 1993



How do you change the ignition switch on a 92 Mitsubishi Mirage hatchback?

I changed the whole ignition in a 93 colt. I got the replacement from a lancer!The ignition wraps round the steering column and is bolted with sheer away bolts. The bolts are designed to break when originaly tightend (Antitheft). you will have to use a hacksaw blade to cut slits in the top of the bolts that are on the suspect ignition. when slits are deep enough, use a flathead screwdriver to remove them. You will have to get new bolts from your Mitsubishi dealer. when its off the ignition switch is held by a Philips screw, remove and continue with putting the replacement ignition on! hope it helps!!




What is the towing capacity for a 1992 Plymouth colt vista?

Are you joking? The correct answer is 1 cooler of beer.


Why doesn't the rear hub on a 1989 Plymouth Colt tighten up?

Threads are stripped or bearing is disintegrating.


Where is the Horn location on Plymouth colt vista1993 2.4L?

Its on the passenger side right behind the front bumper.


Where is the fuel pump on a 1995 Plymouth colt vista?

The fuel pump is in the top of the gas tank unfortunatly.


How much does a ignition cost for 92 colt?

check auto zone.com Napa auto parts.com


What is the weight of the Plymouth colt?

mine is a 91 2 door hatch back and it says it ways 1770 pounds



What is causing first and second gear to malfunction in a 1991 Plymouth colt?

The overdrive. Try driving it with the overdrive off.


What is the button on your floor board of your 92 Plymouth colt vista for?

Try it with your lights on, its probably your Hi-lo dimmer.


Where is the inertia switch located on a Dodge colt?

Dodge does not use inertia switches.


How do you check the transmission fluid in a Plymouth Colt?

In this job, you have to go under the car. I bought a book on 1989 Plymouth Colt E in 2005, but I don't think the sell them now. Anyway, 1.Get under the car were the gear box is. There you will find Screws. Un screw them and take that off. (they may be rusty) And there you go my friend!



What makes the brake lights work on a 93 dodge colt?

There is a brake light switch or stoplight switch that may be bad on the brake pedal up top.




Where is the ignition power transistor on a 94 dodge colt?

most likely it will be on the drivers side right up against the fire wall


Still have questions?

Trending Questions
What are fat burning foods? Asked By Wiki User
What is half of 16? Asked By Wiki User
Do potatoes have genders? Asked By Wiki User
Unanswered Questions