answersLogoWhite

Be the first to answer!

Who doesn't love being #1?

Be the first to answer this question.

Related Questions


Replace ignition switch for 1993 buick century?


IGNITION ? ARE we talking ignition coil-ignition wires ignition switch-key & tumbler.


Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.



IF anyone has any imfo on how best to replace an ignition system on a 1993 Mercury topaz please call 714-6383162, or e-mail me at KN657@yahoo.com


It's really easy the switch is in the steering colume.


Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.


The 1993 Mazda. reverse light switch is located below the shifter column. The relay switch can be seen by removing the center console.


how do you replace the headlight switch on a 1993 cutlas ceria*



The 1993 Mazda the inertia?æswitch can be found on the firewall in the engine compartment. The inertia switch will be on the passenger side of the firewall.


I believe that the switch is located in the ignition cylinder (which you can get from any auto parts store). Unfortunately you'll need a steering wheel puller and a tilt removal mechanism before you can start with that.


It depends on what part of the country you live in. Call a couple of local garages for estimates.


On a 1993 Mazda Protege, neutral safety switch (also called the shift interlock switch) is located at the top of the brake pedal. It is situated between the headlight relay and the clutch switch.


How do I change the dimmer switch on my 1993 corvette?


The neutral safety switch, release switch, or brake switch is bad.



Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.



you will need security type star screw drivers , remove three screws from bottom of column cover,remove three screws from ignition switch.Replace with new switch.



On the right side of the steering wheel.


I had the Suby dealer in Auburn WA fix mine, the unit is held in place with 2 long bolts. The metal brackets are welded together and the electrical connections have to be soldered to the new Ignition switch. Cost-$289 or so.




Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.