Dodge Caravan

How do you replace the license plate bulb in a 1993 Plymouth Caravan?

8910

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 21:00:36
2011-09-12 21:00:36

yes it is easy all u need is a Philips screw driver open the hatch and it wilol be eye level so u can see the bulb easy. just unscrew the cover and pull the wire out a little and the pull out the old bulb asnd push in the new one

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you replace the license plate lights on a 2000 celica?

how to replace the license plate bulb on a 2004 Honda cr-v

how do you replace a honda crv licence plate bulb on a 2004

how do u change the license plate light on a 2005 sienna

how do you replace license pate light on 2006 pontia g6

The license plate light and connected right above the plate on a 2002 Volkswagen Beetle. To replace it just unscrew the old light and mount the new bulb.

unscrew the bulb in the opening above the rear license plate holder- bring the bulb to an auto parts dealer then replace the bulb

The license plate bulb is located right above the plate on a 2002 Oldsmobile Bravada. To replace the light simply remove the old bulb and install the new one.

Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.

It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.

Open your trunk the two inner bulbs are for your license plate twist and should pop right out

How do you change the liscence plate light fuse

You need to unscrew the whole cover panel for license plate.

The license plate light on a 1995 Olds Cutlass Supreme can be replaced by accessing the bulb through a hole in the bumper next to the license plate. A person may need to do this from underneath the vehicle.

You can replace the license plate light bulb on a 2002 Ranger by reaching under the rear bumper and pulling out the light socket. Remove the bulb and put the new one back in.

Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.

Remove the screws from the lens covering the bulb, pull out the bulb and replace it.

license PLATE SEARCH

Who invented the license plate?

Open up your trunk and look up above the license plate. It is held in by screws. undo the screws adn unit drops down.

The license plate lights are located just above the license plate. Open the tail gate part way to make removal easier (unless you enjoy squatting). Remove the Phillips screws and replace the affected bulb.

You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.