Open your trunk the two inner bulbs are for your license plate twist and should pop right out
push up and turn on the housing
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
The clear covers for the license plate light bulbs have small arrows pointing in one direction. Simply push the cover to the direction of the arrows and the covers will slide off allowing for the old light bulbs to be replaced.
How do you replace the license plate lights on a 2000 celica?
OPEN THE TRUNK LID. JUST INSIDE THE LID BEHIND THE LICENSE BULB CASE ARE 2 PHILIP HEAD SCREWS THAT REMOVE THE BACKING PLATE. ONCE YOU REMOVE IT YOU CAN REPLACE BOTH LITTLE BULBS. THEN PUT THE PLATE AND SCREWS BACK IN YOUR READY TO GO.....
If you can not remove fasteners on outside, you may need to cut a section out of the inside of trunk to get your hand by the bulbs.
bring it to your ford dealer, that's what techs are there for.
yes 2002 Ford Focus do have 2 lights on license plate
Remove the screws that hold the covers in place. Replace bulbs!
The 2001 Ford Focus Owner Guide shows : ( C-5W , license plate lamp )
There are two (2) lights directly above the license plate. Each light has two (2) screws. Remove these screws and the covers. Lights pop out with little effort. Replace bad bulbs with size 194 lights. These are approx $2 at walmart or an auto parts store. Once bulbs are replaced, reattach covers with the screws and you should be good to go.
On top of the license plate is a clear plastic lens with 2 screws in it. Take it off. Then a bulb slides into the holder, then replace the lens. There are 2 bulbs. One on each side.
in the rear facia, under the trunk lid there is 9 bolts holding the facia on. You must remove the nuts and pull the facia out and right above the license is the two bulbs 194. replace the bulbs and put the facia back on and you are on your way.
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
you need to remove the inside panel to get to these bulbs
how to replace the license plate bulb on a 2004 Honda cr-v
Reach under the car and feel the back of the license plate light. There's a metal clip, which when squeezed, will allow you to easily pop the license plate light out. Then simply twist the part holding the bulb 90 degrees, and you'll be able to pull the socket out and replace the bulb.
on the 2001 XZ3 I removed the license plate and used a flat head screw driver to slid the license plate light cover over and they "pop" out.
how do you replace a honda crv licence plate bulb on a 2004
how do u change the license plate light on a 2005 sienna
· lugnuts · light bulbs · license plate holder
Replacing license plate lamp bulbsThe license plate bulbs are locatedbehind the rear bumper. To changethe license plate lamp bulbs:1. Reach behind the rear bumper tolocate the bulb.2. Twist the bulb socketcounterclockwise and carefully pullto remove it from the lampassembly.3. Pull out the old bulb from thesocket and push in the new bulb.4. Install the bulb socket in lamp assembly by turning it clockwise.
how do you replace license pate light on 2006 pontia g6