answersLogoWhite

0


Best Answer

Cut two pieces of trimmer line about 6-8 ft long. Push the line into the opening in the spool until it comes out of the bottom of the spool. Place the end of the line into the small hole adjacent to the opening where the line came out of the spool. Pull the line tight while holding your finger on the line in the hole. Do this for both sides and then wind the spool in the reverse direction to fill the spool. Pull on the line occasionally to make sure the line is not binding up in the spool.

There are spools that will take one single long line, where the center of the line is attached to a notch (or similar) in the center of the spool and then wound with one line on each side of the spool. Then, the end of each line is threaded through each hole in the trimmer head. It would be best if you consulted a user's manual. Try the following website for a downloadable manual for your application: managemylife.com or manualsonline,com

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the line on a spool with two lines coming out of the spool?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix a jammed weed wacker?

Stop motor. Remove line spool. pull spool from shaft and remove cord or weeds from around shaft. Replace spool on shaft. Re start motor.


How can you replace the trimmer line mac 2816?

Locate the trimmer head at the shaft. Remove debris in the head. Cut a 14-inch piece of the trimmer line and fold it. Place the spool against the spindle. Feed the ends of the line through the eyelets. Push the spool down and pull the trimmer line tight with your hands. Tighten the spool.


How do you replace the line on your closed face fishing reel?

First, remove the reel cover. Remove old line carefully, when you find the end, it should come off easily. Once the old line is removed, run the new through the cover, then tie the new line on the spool, and remember to remove the tag end as close as possible to the spool. Replace the cover, then reel the new line on the reel.


Cant get the spool out of a craftsman line trimmer?

1. Rotate spool to line up arrows on spool and surrounding casing. 2. Find notch and pry with wide flat-end screwdriver. 3. Spool will pop out.


How do you replace the brake line on a grand am?

How do i replace brake lines on a 2000 grand am


How do you replace brake lines on 1998 blazer?

replace the line and fill and bleed breaks.


How you prepare the reel with line?

First release the spool from the reel. Then take a length of string and tie it to the spool use a small knot keep it tidy.You then wind the string onto the spool in a clockwise direction until it covers approx 1/8 of the capacity of the spool.You then attach the nylon fishing line or braid,to the string with a small tidy knot and try hiding the knot on the outer edge of the spool.You then lift up the bail arm of the reel and refit the spool and close the bail arm.You would then load your line onto the reel until 1-3mm from the top of the spool, Be sure to wind the lines reasonably tightly.


How do you re string dual no bump weed eater?

it actlly all depends on which head you have...but regardless always roll spool putting the line on it, don't roll the line, but the spool, keeps the line able to come off when bumping, if you wind the line around the spool it will normally melt and prevent it from feeding.


How do you change the line in a weed whacker?

I removed the gas tank from the weedwhacker and pulled off the old fuel lines with needle nose pliers. Both hoses have something at the end of them that you can re-use on the new fuel lines. Pull the fuel filter off the end carefully. May have to split the line with a razor knife where it has become brittle where it attached to the carb or the fuel filter down inside of the gas tank. Went to Ace Hardware and they sell the fuel line by the foot. That will be more than you'll need. Push the new fuel line through the holes in the gas tank that the original lines came out of and with the needle nose pliers pull the lines up through the fuel filler hole and put the end pieces back on as they were before. Put the lines back into the fuel filler hole & re-install the gas tank on the weedwhacker. Trim the fuel lines to the proper length and re-attach the connections to the carb. May want to replace the spark plug at the same time. Good as new.


What is in line hockey?

Lines refer to a group of players who play together on the ice. When you run a line change, you replace the players on the ice with new lines.


How much line per turn does a zebco 33 classic 1985 reel retrive?

That depends on how much line is on the spool, if the spool is empty then each turn retrieves less line then when it is nearly full.


How do you fix the AC from blowing out the defrost on a 1997 Dodge 1500 4x4?

Look for a broken vacuum line coming out near the ac lines on the passenger side under the hood.Look for a broken vacuum line coming out near the ac lines on the passenger side under the hood.