answersLogoWhite
Headlights Tail and Brake Lights
Chevy Tahoe
Chrysler Sebring

How do you replace the low beam headlight bulb on a 1996 Chrysler Sebring coupe?

818283

Top Answer
User Avatar
Wiki User
2015-07-15 19:03:50
2015-07-15 19:03:50

There are 2 round caps on the rear side of light housing, under the hood. You have to unscrew them. You then should see the light wiring. You have to remove a little metal clip that hold the light bulb in place, unclip and remove light.

1

Related Questions

User Avatar

It is not a direct swap. They use different transmissions, computers, wiring, etc.

User Avatar

Nope I have tried for my 01 coupe it's the same as yours but so far no luck

User Avatar

A Chrysler Sebring does not have a reset switch.

User Avatar

How do you replace a fuel pump for a 1998 Chrysler Sebring Lxi Coupe ?

User Avatar

The first Chrysler Sebring was a Coupe (hardtop) & was released in 1995, the Sebring Convertible didn't get released until the following year - 1996.

User Avatar

2004 CHRYSLER SEBRING COUPE = 4.6 Qts W/Filter 2004 CHRYSLER SEBRING SEDAN = 5 Qts W/Filter Hope This Helps.

User Avatar

A 2003 Chrysler Sebring is fuel injected and does not have a choke.

User Avatar

The 1997 Chrysler Sebring transmission is equipped with two transmission mounts. There will be a transmission mount at the back of the transmission, on each side.

User Avatar

Very few if any will fit. They are different body styles with different engines.

User Avatar

2004 Chrysler Sebring headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

Chrysler/Dodge/Jeep vehicles do not use inertia/reset switches.

User Avatar

Coupe is different than sedan. See sources and related links below for a wiper blade size listing for the 1999 Chrysler Sebring.

User Avatar

Unlock the door with a key or use the remote.

User Avatar

On a coupe, it is under the hood. On a convertible, it is inside the driver side fender.

User Avatar

Coupe, under the hood. Sedan and convertible, inside the driver side fender.

User Avatar

It is on the radiator side of the engine, under the engine mount.

User Avatar

On my 2001 LXi coupe, it is in the grill, at the top right.

User Avatar

Group size 86 is the specified size. for a Chrysler Sebring Coupe LXi.Group size 26 is an alternate, but make sure of the measurements BEFORE you buy.

User Avatar

It is inside the fuel tank. The tank needs removed to access.

User Avatar

Leave any repair of the SRS to an expert. Serious injury can occur.

User Avatar

Coupe, under the hood. Convertible, inside the fender, in front of the driver side tire.

User Avatar

Four cylinder has four. Six cylinder has six.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.