Best Answer

There are 2 large 7/16ths screws (both colored black), both on the top of the headlight assembly. Remove both of them, then pull the assembly out towards the front of the car. You might have to pull out on the bottom of the assembly first to remove it. Once the assembly is removed, look at the back of it...The Low beam bulb is the one closest to the yellow signal bulb. The other one, furthest away from the signal bulb is the high beam. Remove the wire clip from the bulb you want to change (you might have to use a small screwdriver to release the plastic catch). Once the wiring is removed, turn the light socket counterclockwise (looking at the back of the assembly) to remove the bulb from the assembly. Just reverse the procedure to put the new bulb into the assembly. When done, put the assembly back in place and replace the two long screws.

User Avatar

Wiki User

โˆ™ 2008-05-27 00:05:52
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the low beam headlight on a 2001 Dodge Intrepid?
Write your answer...
Sign up for more answers

Registered users can ask questions, leave comments, and earn points for submitting new answers.

Already have an account? Log in

Related questions

Where is the cabin air filter for a 2001 Dodge Intrepid?

The 2001 Dodge Intrepid does not have a cabin air filter.

Will 2002 dodge intrepid wheels fit 2001 Dodge Intrepid?


Is there an inertia switch on a 2001 Dodge Intrepid?

No. A 2001 Intrepid does not have an inertia switch.

Where can i find the Egr valve on a 2001 Dodge Intrepid 3.5 liter?

where can I find the egr valve on a 2001 dodge intrepid 3.5 liter

Can you replace a 2.7 motor with a 3.5 motor in a 2001 Dodge Intrepid?

Yes, with the computer, harness, and plumbing from the 3.5L

What could cause a 2001 Dodge Intrepid to click when trying to start?

the solenoid on your starter is finished, replace the starter......

Why leak on thermostat housing 2001 dodge intrepid?

There's a gasket between the thermostat and the block that you need to replace.

What is the 100000 maintenance for 2001 Dodge Intrepid?

Flush and replace the engine coolant. Replace the engine timing belt or chain. Replace the spark plugs & wires.

Reset oil change light on 2001 Dodge Intrepid?

A 2001 Intrepid does not have an oil change light.

Will a 2001 intrepid motor fit inside a 2000 Dodge Intrepid?


How do you change the license plate bulb in a 2001 Dodge Intrepid?

It is very easy to change the license plate bulb in a 2001 Dodge Intrepid. You will need to remove the tag and then unscrew the light cover. After the cover is off, unscrew the light and replace with a new one.

What does it mean if the blower fan in a 2001 Dodge Intrepid will only work on high speed?

replace the blower motor resistor

How do you replace the headlight on a 2001 dodge ram 1500?

Open the hood to your 2001 Dodge Ram 1500 engine compartment. Take hold of the headlight connector. Push the connector in and turn at the same time. Do the same with the headlight bulb. Reverse the process to install the new lightbulb.

Will a 1997 engine fit in a 2001 Dodge Intrepid?


Where is the flux capacitor on a 2001 Dodge Intrepid?

It does not have one.

How do you replace a fuel pump on a 2001 Dodge Intrepid?

Located in the fuel tank- may have to remove if there is not an access panel in trunk area

How do you replace the headlight bulb located on a 2001 Toyota Celica?

how do you replace headlight bulb in a 2001 celica gts

Will a 1998 Dodge Intrepid motor fit in a 2001 chrysler intrepid?

If same size, yes.

Is a rear and front wheel drive 2001 2.7 Dodge Intrepid motor the same?

The Dodge Intrepid was always front wheel drive.

What is most common 2001 Dodge Intrepid problems?

The engine.

What kind of oil do you put in a 2001 Dodge Intrepid?


What type of oil for 2001 Dodge Intrepid 2.7?


Is there a reset button for fuel pump on a 2001 Dodge Intrepid?


What Gear Oil does a Dodge Intrepid 2001 use?


Where is the oil filter located on a 2001 Dodge Intrepid?

The oil filter in a 2001 Dodge Intrepid is located on the driver's side of the engine. The filter is in the front of the engine, over the frame of the car,