answersLogoWhite
Audi A4

How do you replace the low beam xenon bulb on a 2002 Audi A4?

353637

Top Answer
User Avatar
Wiki User
2006-02-08 22:05:23
2006-02-08 22:05:23

Check the bulb to see if it's is D1S or D2S, it is probably D2s. If you can't tell, the ignitor (what plugs righ tinto the bulb) will tell you. A square ignitor is D1s, and a round one is D2s. There are lots of sources for replacement bulbs, I got one at hidplanet.com.

1

Related Questions

User Avatar

I have a 2000 S 430, and when my dash read "low Beam" I actually had to take it to the dealer to replace because of the new Xenon headlights, the bulb itself ran me $160.00!

User Avatar

Take it to a dealer. There's no way you'll do it. Proud owner of one.

User Avatar

replace low beam bulb 2006 kia senoda

User Avatar

If only the low-beam is out, you will need to replace the low-beam bulb. It is probably not necessary to replace the entire headlight assembly.

User Avatar

this is only one of many but if you do go with something reputable cause you dont want to have to replace due to poor quality, and make sure to get a bi-xenon h-13 bulb (high and low beam) for the 08 escapehttp://www.philipsxenon.com/ford-xenon-c-339/ford-xenon-lights-kit-by-philips-p-1224

User Avatar

how to replace high/low beam, turn signal lever on 1996 subaru outback wagon

User Avatar

replace the bulb. the high beam filament is burned out.

User Avatar

was wondering this aswell.......halfords supply and fit more powerful headlight bulbs....give them a try.

User Avatar

The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.

User Avatar

Filament for low beam is burnt out. Need to replace.

User Avatar

Probably the high beam switch in the steering column is bad.

User Avatar

The Brightest thing on earth is the Luxor Sky Beam in Las Vegas. It consists of digitally designed curved mirrors which collect light from 39 xenon lamps and focus them into one narrow beam.

User Avatar

Replace the left size high beam light.

User Avatar

Well, first i would replace the low beam bulbs, if that doesn't work, perhaps a fuse, and if not that, wiring problems.

User Avatar

low beam - 9006 high beam - 9005 according to the owners manual

User Avatar

Should only be one per side. I would imagine it would be a Sylvania 9007 bulb. They are dual beam in a 2002 so I believe that its the same. Dual beam as in both bright and dim.

User Avatar

most likely problem is that the low beam side of bulb or sealed beam is burned out replace with a new one

User Avatar

go to your nearest Mitsubishi dealer and request a high beam light replacement.

User Avatar

Bulb or faulty wiring i would think. HTH

User Avatar

The daytime running lights are the low beam lights run by a specific circuit. If they don't work then check your fuses and then the wiring harness for damage.

User Avatar

The headlight has two filaments. One for the high beam and one for the low beam. The most likely reason the high beam is out is because the high beam filament is broken. Replace the bulb and it should fix it.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.