answersLogoWhite

0


Best Answer

The sending unit is located just above the oil filter. Reach through the passenger side wheel well splash shield, remove it or just position it out of the way, and disconnect the connector. There is a special deep well socket you can purchase or just use a 27mm open end wrench as I did. There is enough room to get the wrench on the flats and turn the sending unit out from underneath the car. Reverse the procedure to install.

User Avatar

Wiki User

โˆ™ 2009-10-11 03:15:11
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the oil sending unit wgauge on a 1996 Buick LeSabre Limited?
Write your answer...
Submit
Related questions

How do you replace fuel level sensor on 2001 lesabre?

Replace sending unit which is located inside gas tank (gas tank must be removed from car).


How do you replace front axle on 2001 Buick Lesabre?

Replace axle on 2001 buick Lesabre


How do you replace the fuel pump on a 1997 Buick LeSabre?

how do you replace the fuel pump on a 1997 buick lesabre


What the difference between 1992 Buick LeSabre Custom and Buick LeSabre Limited?

Custom is lower end. Limited has more features.


Where is the relay located in a 1987 buick lesabre limited?

where is the relay located on a 87 lesabre


What is the difference between 2002 Buick lesabre limited and 2002 Buick lesabre custom?

With Buick, The "Limited" is always the more expensive upgrade version.


How do you replace a thermostat in a 1993 Buick Lesabre?

where do the thermostat go in my 93 buick lesabre


How do you replace the heater core in a 1999 Buick lesabre custom?

how much would it cost to replace the heater coil on a 1999 buick leSabre


Heater core removal 98 Buick lesabre?

How do I replace heater core on 98 Buick lesabre


Is there a diagram of the engine of a 2003 Buick leSabre limited?

Thanks


How to replace a serpentine belt on 1994 buick lesabre?

replace tension put it on


How do you replace actuator on 97 buick lesabre?

what actuator?


What is the weight of a 1993 Buick LeSabre?

The 1993 Buick LeSabre Limited 4 door sedan has a curb weight of 3,454 lbs.


How do you replace the fuel filter on a Buick LeSabre?

How do you replace fuel filter on 1993 Buick LeSabre, the replacement filter I bought appears to be a snap on. I have only replaced the screw on type.


How do you replace the wiper motor on Buick LeSabre?

Check www.autozone.com, they have a Repair Info section that covers Buick LeSabre with this info.


How do you replace a turn signal switch on a 1990 Buick LeSabre?

It is quite simple to replace the turn signal switch on your 1990 Buick LeSabre. The turn signal switch simply plugs in and out.


How much should it cost to replace ball joint for buick lesabre?

Cost on replacing ball joints on a 2001 Buick lesabre


How many 1985 Buick LeSabre Limited collectors Edition were Manufactured?

500


Where is the twilight sentinel sensor for 2000 Buick Lesabre Limited?

probably on dash


How do you tuneup a 2002 Buick LeSabre?

Replace Spark plugs Replace Wires Replace fuel Filter Replace PCV Valve Replace air Filter


Can you change out the dash in a 1988 Buick lesabre custom with the dash out of a Buick lesabre limited?

Yes you can. The only difference between the Custom and the Limited is the trim level (Seat fabric, wood grain, etc.) Everything else is interchangeable.


How do you change a starter gear in a 1991 buick lesabre?

replace starter


How do you replace a vent solenoid in a Buick lesabre 1993?

help me i need this answer :- (((


How do you replace sending unit on a 2006 Chevy Malibu?

Need to know which sending unit you want to replace, there are several.


How do you replace window regulator in 2003 Buick LeSabre front driver side?

The way that replace a window regulator in a 2003 Buick LeSabre front drive side is by removing the door panel. Next, disconnect the electrical connector on the regulator and replace.