answersLogoWhite

0


Best Answer
Copy

I replaced mine on a 99 C280 and would imagine it should be the same or similar on yours. The glass headlamp cover is held in place by about 6-7 steel clips that are accesible with the hood open. Make sure when you replace it that you also replace the rubber gasket that lays in the 'gutter' where the lip of the glass cover will sit. I bought mine online for about $80-90. Since the one I was relacing was already broken, installing the new one took less than 30 minutes.

2007-04-09 16:28:22
This answer is:
๐Ÿค“
๐Ÿคฏ
๐Ÿค”
User Avatar

Your Answer

Loading...

Related Questions

How do you replace the headlight bulb located on a 2004 Pontiac Grand Am?

1. Open the hood. 2. Remove the front air deflector. 3. Apply light pressure to the headlamp lens to hold the headlamp assembly in place while disconnecting the retainers. 4. Lift up the headlamp assembly retainers to release. Important: Note the location and position of the headlamp adjuster retainers and the locator tab. 5. Remove the headlamp assembly, pulling straight forward from the headlamp mounting panel. 6. Disconnect the wiring harness from the headlamp assembly. 7. Rotate the headlamp bulb/socket counterclockwise to release. 8. Remove the headlamp bulb/socket from the headlamp assembly, if required. There are (2) pull up clip retainers that hold the headlamp assembly in place...Both of these must be removed for the headlamp assembly to be pulled forward...:)


How do you remove the headlight assembly located on a 1998 Pontiac Grand Prix?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. G These instructions are similar from around '96 to '03 grand prix model years all trim levels.


How do you replace the headlight assembly on a 2000 Dodge Caravan?

Open hood, remove headlamp bulb from headlamp assembly, remove (1) 10mm bolt from top of headlamp assembly, next remove (3) 10mm bolts from behind headlamp assembly, pull headlamp forward ( you may have to pry gently from the right side). Remove turn signal bulb-Done!


How do you remove the headlight lens on a 2000 Pontiac grand prix?

Remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. G These instructions are similar from around '96 to '03 grand prix model years.


How do you replace the headlights on a 1998 Pontiac Grand Prix GTP?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. . G These instructions are similar from around '96 to '03 grand prix model years all trim levels.


How do you replace the headlight bulb located on a 1999 Pontiac Grand Prix?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. (to release the tabs from the slots on the passenger side lens move the assembly to the left when facing the engine, and when doing the drivers side lens shift the assembly to the right ) Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. "G" These instructions are similar from around '96 to '03 grand prix model years all trim levels.


How do you replace the headlight bulb located on a 1995 Pontiac Grand Prix?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. (to release the tabs from the slots on the passenger side lens move the assembly to the left when facing the engine, and when doing the drivers side lens shift the assembly to the right ) Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. "G" These instructions are similar from around '96 to '03 grand prix model years all trim levels.


How do you change a headlight in a 2001 Pontiac grand prix?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. (to release the tabs from the slots on the passenger side lens move the assembly to the left when facing the engine, and when doing the drivers side lens shift the assembly to the right ) Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. . "G" These instructions are similar from around '96 to '03 grand prix model years all trim levels.


How do you replace the headlight assembly located on a 2001 Lincoln Continental?

for the removal, pull of the upper radiator sight shield, make sure that the headlamp switch and the ignition switch are turned off, raise the headlamp assembly retainers by pushing rearward and then pulling up to save time. disconnect the headlamp assembly wiring harness and remove the headlamp assembly, install just do the reverse.


How do you replace the headlight bulb located on a Pontiac Grand Prix model years 1996-2003 all trim levels?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. G These instructions are similar from around '96 to '03 grand prix model years all trim levels.


How do you remove headlight assembly on 2004 buick lesabre?

simply remove the two screws located on the top of the headlamp assembly and then pull the headlamp assembly forward to gain access to the light bulbs


How do you remove a headlamp on 1998 mercury tracer?

Open the hood to the engine compartment. Remove the headlamp wiring harness. Remove the headlamp assembly retaining bolts. The headlamp will come out.


How do you replace headlamp assembly?

If you are referring to the Chevy Venture, it is relatively easy. Just remove the 3 wing-nuts that hold the assembly secure, and then pull the headlamp assembly out. I have a link that shows how to do this, with actual pictures.


How do you replace the headlamp bulb in a Mercedes A140?

ask someone else to do it


How do you change Headlamp assembly on 2004 impala?

See Headlamp Assembly removal, under Section 5: Service and Appearance Care - Bulb replacement, on page 5-53 of your "Owner's Manual"...


How do you change the front signal light bulb on a 1997 Pontiac Grand Prix?

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. This gives you access to the turn signal and headlight. If you wish to change the halogen bulb: Disconnect the electrical connector from the turn signal bulb/socket. Remove the turn signal bulb/socket retainer ring from the assembly, by turning counterclockwise. Remove the turnsignal bulb/socket from the assembly. to re-assemble simply do the reverse. . "G"


How do you replace headlight lamp on 2004 Chevy Venture?

Hi,The headlamp bulb is relatively easy to replace in these vans. What you have to do is remove the turn signal assembly first, and then the headlamp assembly. This is done by removing 3 wing nuts that hold the assemblies in, and then pulling the turn signal assembly straight out, followed by the headlamp assembly. The headlamp assembly has to be lifted UP and then Out.Once you have the assembly out, the headlight bulb can be unscrewed from the back of the assembly and replaced. Be careful not to get any oil from your fingers on the new bulb, as that will heat up when the light is on and decrease the lifetime of the bulb.I have included a link below that shows pictures of the assemblies and how to removed them.Take Care, Greg


How do you get dirt out of your headlamp assembly?

You have to lift up your hood and and youll see the headlamp but you also could poor gas and turn on your car.


How do you change a headlamp on a 2001 Nissan Altima?

back of assembly and twist.


Is the headlight plastic lens removable?

No, the headlamp assembly is a single unit.


How do you change the headlamp bulb in a 2003 Grand Prix?

Caution Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury: Turn off the lamp switch and allow the bulb to cool before changing the bulb. Leave the lamp switch OFF until the bulb change is complete. Always wear eye protection when changing a halogen bulb. Handle the bulb only by its base. Avoid touching the glass. Keep dirt and moisture off the bulb. Properly dispose of the used bulb. Keep halogen bulbs out of the reach of children. Raise the hood. Remove the headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly.


How Replace xenon headlamp bulb Mercedes E320?

Carefully! there very expensive.


How do you change a headlight bulb on a 2003 s-10 Chevy?

Standing in front of the bad headlamp, with the hood open, notice the two black tabs sticking up behind the headlamp assembly. These are locks that hold the headlamp assembly in place. Remove the locks by wiggling and pulling straight up. Now the headlamp assembly will drop out the front far enough to twist out the bulb socket to change the bulb. Reverse for installation.


How do you replace a headlamp bulb on a 2004 Chevy Blazer?

this is what owners manual says: 1-piece composite headlamp system 1. Open hood 2. Remove the black retainer clips by lifting up 3. Pull the headlight assembly out 4. Unplug the electrical connector 5. Turn the bulb/socket assembly counterclockwise to remove it 6. Put the new bulb/socket assembly into the headlamp assembly and turn it clockwise until it is tight 7. Plug in the electrical connector 8. Put the headlamp assembly back into the vehicle 8. Install the two retaining clips 10. Close the hood 2-piece composite headlamp system: 1. Open the hood 2. Remove the black retainer clips by lifting up 3. Unplug the electrical connector 4. Pull the headlamp assembly out 5. turn bulb/socket assembly counterclockwise to remove it 6. Put the new bulb/socket assembly into headlamp assembly and turn it clockwise until it is tight 7. Plug in electical connector 8. Put the headlamp assembly back into the vehicle 9. Install the two retaining clips 10. Close hood


How do you replace the front light bulbs on a 2003 Kia Sedona?

You have to remove the entire headlamp assembly from the vehicle to access the headlamp bulb. Not too difficult, just 3 or 4 screws I think. Everything is pinned, or keyed, so you don't have to readjust the assembly after replacing the bulb & attaching the headlamp.