answersLogoWhite
Honda Prelude SI

How do you replace the oxygen sensor on a 1986 Prelude SI 2.0?

789

Top Answer
User Avatar
Wiki User
2015-07-16 18:23:40
2015-07-16 18:23:40

Owner: You need to get under the front end and have a 17 mm wrench with you Now this job is very time consuming so be cool. It is a tight spot that your going to be working in . the O2 sensor will be located on the side on exhaust manifold.

1

Related Questions

User Avatar

The oxygen sensor is in the top center of the rear exhaust manifold.

User Avatar

The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.

User Avatar

oxygen sensor is found either in exhaust manifold or in actual exhaust pipe between manifold and muffler

User Avatar

It is in the exhaust system before the catalytic converter.

User Avatar

I know for sure that the 87 accord does and I think that all Honda cars have tis feature

User Avatar

Just downstream after the exhaust manifold

User Avatar

You need to replace the entire headlight. Only remove the screws that hold the trim in place. Don't back out the adjustment screws.

User Avatar

The 1986 Honda prelude 2.0 Si has a A20a3.

User Avatar

A cam sensor and crank sensor was not used on that year. If the engine is not firing then I would replace the ignition module that's in the distributor.

User Avatar

There are a couple of reasons why a 1986 Isuzu will not idle. One reason could be the oxygen sensor and another reason could be in the fuel system.

User Avatar

my Honda prelude 1986 si wants to cut off after its warmed up . any sugestions on what ot could be

User Avatar

I'm sorry but there is no euro's available for a prelude under 1992. well I believe, that is why i just got a 94 prelude se

User Avatar

Check up by the manifolds or anywhere before the catalytic converter.

User Avatar

Dragon Ball - 1986 Prelude to Vengeance 4-17 was released on: USA: 29 September 2003

User Avatar

look right before the converter unless your pipes has been changed

User Avatar

its like my 91 Prelude 5 speed transmission is stuck in 2 gears.It is wielded.

User Avatar

On the crossbars of the steering wheel.

User Avatar

Make sure your computer has no viruses

User Avatar

There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one

User Avatar

I had a 1987 Jetta and the oxygen sensor was connected to the down pipe. It is screwed in and there should be a wire leading from it. From the engine compartment you can look near the firewall and follow the exhaust pipes. It should be sticking out midway between the top and bottom bends.

User Avatar

Most oxygen sensors are located on the exhaust manifold or just after the manifold on the exhaust pipe(s). Your truck probably has two oxygen sensors, one on each side.

User Avatar

They do if it is an automatic transmission. The Prelude (except Si) has the same manual transmission as well. The Prelude Si has a slightly different manual transmission, but it will still fit into a 1986-1989 Accord.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.