It screws into the exhaust near the manifold. I haven't had to change mine on my intrigue, but if it's like others I've had to change, you get to it under the car behind the engine. Follow the exhaust from the catalytic converter up to the manifold, it should be the only sensor with a wire coming out of it that is screwed into the exhaust pipe. Unplug it from the wire harness, then unscrew it using a flat wrench. Have a new one ready to install, you can't run the car without it. Hope this helps.
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
in front of the converter
Can you show me a diagram of the upstream oxygen sensor on a 3.5l liter Oldsmobile Intrigue engine?
The oxygen sensor on a 1999 Oldsmobile Intrigue 3.3 liter is in the exhaust manifold/pipes
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
Never heard of an "ignition sensor". Do you mean oxygen sensor, or maybe crank position sensor, or cam position sensor? There is an ignition "module" also... The oxygen sensor is on the exhaust manifold. The crank posiiton sensor is on the backside of the block. The cam position is on each head.
A 1969 car would not have an oxygen sensor.
For 3.5l, remove starter.
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
Its either your cam shaft position sensor or the crank sensor.
looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.
The engine won't start.
It is located above the starter. you must remove the starter for access. Make sure you disconnect the battery first.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
1st o2 senor is between exhaust. 2nd o2 sensor is under shifter
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.
The 2002 VW oxygen sensor is quite simple to replace. Remove the wiring harness. The oxygen sensor will simply pull out.
The crank shaft positioning sensor is behind the starter. A real bear to get to.
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
just above the starter on the front of the motor. will have to take the starter off to get to it.
See related answers
No, they are two seperate sensors.