Remove four screws. Lift off slowly, making sure to disconnect any wiring harnesses, etc., that may be connected to it. That'll get the top plate off, anyhow.
The 1998 Chevy Corvette parking brake can be adjusted with the parking brake adjustment bolt. You can also adjust the parking brake cable.
== ==
The parking brake wire is located under the center console. Around the parking brake there is a wire that routes to handbreak, it is normally green.
Check brake fluid level. Check parking brake switch- make sure it is fully depressed and has not become misaligned.
video on how to replace parking brake cable in ford escape 2003
== ==
May be a bad master cylinder, a bad sending unit from the master cylinder or the parking brake or the parking brake is not completely disengaging.
To adjust the parking brake, first open the middle console and remove the small plastic square. Under the square is a bolt that you must loosen. Once this is loosened, take the console cover off. On the driver's side of the parking brake, there is a nut that you can loosen or tighten to adjust the tension of the brake.
ask this question on digitalcorvettes.com in the c3 forum...you will get a good answer
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?
On the center console near the parking brake handle
There should be a parking brake lever above the parking brake pedal that you pull to disengage the parking brake. It depends on the type you have; if it is a pull-up lever in your center console they can give you a little trouble. Pull it up slightly and while you have upward pressure press and hold the button on the end, than it will drop.