answersLogoWhite
Headlights Tail and Brake Lights
Jeep Liberty
Toyota 4Runner

How do you replace the passenger side brake light on a 2004 Jeep Liberty?

424344

Top Answer
User Avatar
Wiki User
2007-09-24 16:58:17
2007-09-24 16:58:17

There are two torx screws just inside the door jamb, with door open, remove those, then pull, with just a slight tug, to the outside(your right when standing behind jeep) and pull out , it should pop free. There are two push-in plugs, kinda rivet style, with a bullet head on them and just kinda hold themselves in with the screws. Once it is free, twist the socket that is now visible counterclockwise, and pull bulb out, and replace.

1

Related Questions

User Avatar

w to replace center brake light in 2004 jeep liberty

User Avatar

To replace the brake light switch on a 1995 Tahoe, first disconnect the battery and push the switch up at the ends towards the firewall. Slide the switch towards the passenger side. This will release the brake light switch from the actuator point.

User Avatar

Trying to replace passenger side tailight on a 2002 Jeep Liberty. Cannot disconnect the plug and the replacement connector looks different from the original! Thanks Jim

User Avatar

To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.

User Avatar

How to replace a brake light on a nissan Tiida hatch back.

User Avatar

go into your trunk and you will see little black tabs on the inside un screw those tabs the brake light will then pop right out...

User Avatar

To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.

User Avatar

how to replace the brake light switch at the pedal of a 2001 ford zx2

User Avatar

how to replace brake light bulb fiat doblo van

User Avatar

See sources and related links below for the 2004 Jeep Liberty Brake Light Lamp Numbers.

User Avatar

Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.

User Avatar

How do you replace the third rear brake light in a 2005 buick allure

User Avatar

In order to replace the light, you need to open the trunk and pull back the panels to reveal the plastic wing nuts. Then, loosen the wing nuts and take out the whole lens. Then, replace the light bulb.

User Avatar

Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.

User Avatar

How do you replace the rear brake light bulb on a 2001 Honda civic?"

User Avatar

The brake light switch can be found below the dashboard on the drivers side of the passenger compartment. The brake light switch simply plugs in and out.

User Avatar

just behind the leg on the brake peddle

User Avatar

To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.

User Avatar

How do you remove cover to replace brake light on 57 kia Rio

User Avatar

How to replace passenger side head light bulbs in a 2000 Honda Accord?


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.